|Category||Analog & Mixed-Signal Processing => Amplifiers => Operational Amplifiers => Precision => Dual|
|Description||Precision op Amp: Dual|
|Datasheet||Download OP313 datasheet
FEATURES Single- or Dual-Supply Operation Low Noise: 4.7 nV/ @ 1 kHz Wide Bandwidth: 3.4 MHz Low Offset Voltage: 100 V Very Low Drift: V/ C Unity Gain Stable No Phase Reversal APPLICATIONS Digital Scales Multimedia Strain Gages Battery Powered Instrumentation Temperature Transducer Amplifier
The OP113 family of single supply operational amplifiers features both low noise and drift. It has been designed for systems with internal calibration. Often these processor-based systems are capable of calibrating corrections for offset and gain, but they cannot correct for temperature drifts and noise. Optimized for these parameters, the OP113 family can be used to take advantage of superior analog performance combined with digital correction. Many systems using internal calibration operate from unipolar supplies, usually either +5 volts or +12 volts. The OP113 family is designed to operate from single supplies from +4 volts to +36 volts, and to maintain its low noise and precision performance. The OP113 family is unity gain stable and has a typical gain bandwidth product of 3.4 MHz. Slew rate is in excess of 1 V/µs. Noise density is a very low 4.7 nV/Hz, and noise in the 10 Hz band 120 nV p-p. Input offset voltage is guaranteed and offset drift is guaranteed to be less than 0.8 µV/°C. Input common-mode range includes the negative supply and to within 1 volt of the positive supply over the full supply range. Phase reversal protection is designed into the OP113 family for cases where input voltage range is exceeded. Output voltage swings also include the negative supply and go to within 1 volt of the positive rail. The output is capable of sinking and sourcing current throughout its range and is specified with 600 loads. Digital scales and other strain gage applications benefit from the very low noise and low drift of the OP113 family. Other applications include use as a buffer or amplifier for both A/D and
D/A sigma-delta converters. Often these converters have high resolutions requiring the lowest noise amplifier to utilize their full potential. Many of these converters operate in either single supply or low supply voltage systems, and attaining the greater signal swing possible increases system performance. The OP113 family is specified for single +5 volt and dual ± 15 volt operation over the XIND--extended industrial to +85°C) temperature range. They are available in plastic and SOIC surface mount packages.
Information furnished by Analog Devices is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of Analog Devices. One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A. Tel: 781/329-4700 World Wide Web Site: http://www.analog.com Fax: 781/326-8703 © Analog Devices, Inc., 1998Input Bias Current Input Offset Current Input Voltage Range Common-Mode Rejection
Short Circuit Limit POWER SUPPLY Power Supply Rejection Ratio
Supply Voltage Range AUDIO PERFORMANCE THD + Noise Voltage Noise Density Current Noise Density Voltage Noise DYNAMIC PERFORMANCE Slew Rate Gain Bandwidth Product Channel Separation Settling Time
NOTES 1 Long-term offset voltage is guaranteed a 1000-hour life test performed on three independent lots at 125 °C, with an LTPD 1.3. 2 Guaranteed specifications, based on characterization data. Specifications subject to change without notice.Units V dB V/µV µV µV/° mA % nV/Hz pA/Hz nV p-p V/µs MHz µs
Output Voltage Swing Low Short Circuit Limit POWER SUPPLY Supply Current Supply Current AUDIO PERFORMANCE THD + Noise Voltage Noise Density Current Noise Density Voltage Noise DYNAMIC PERFORMANCE Slew Rate Gain Bandwidth Product Settling Time
NOTES 1 Long-term offset voltage is guaranteed a 1000 hour life test performed on three independent lots at 125 °C, with an LTPD 1.3. 2 Guaranteed specifications, based on characterization data. Specifications subject to change without notice.
|Some Part number from the same manufacture Analog Devices|
|OP32AZ High-speed ( Avcl => 10 ) Programmable Micropower Operational Amplifier|
|OP37 Low Noise, Precision, High Speed Operational Amplifier (A(VCL) >- 5)|
|OP37GP Low Noise, Precision op Amp|
|OP37GR Low Noise, Precision, High Speed Operational Amplifier (A(VCL) >- 5)|
|OP37GS Low Noise, Precision op Amp|
|OP37GT Low Noise, Precision, High Speed Operational Amplifier (A(VCL) >- 5)|
|OP391 Rail-to-rail Single Supply op Amp|
|OP393 Precision, Micropower op Amps|
|OP400 Quad Low-Offset, Low Power Operational Amplifier|
|OP400GP Quad Low-offset, Low-power op Amp|
|OP400GS Quad Low-Offset, Low Power Operational Amplifier|
|OP41 Low-Bias-Current, High-stability JFET Operational Amplifier|
|OP413 Low Noise, Low Drift Single-supply Operational Amplifiers|
|OP4177 Precision, Single, Low Noise Low Input Bias Current Operational Amplifiers|
|OP41A Low-Bias-Current, High-stability JFET Operational Amplifier|
|OP42 High Speed, Fast Settling Precision Operational Amplifier|
AD1584A : 2.5V Micropower, Precisions Series Mode Voltage References
ADP1653ACPZ-R7 : The ADP1653 is a very compact, high efficiency, high power, camera-flash LED driver optimized for cellular phones. The device’s high efficiency and dynamic LED current control improve flash brightness and picture quality in dimly lit environments. Efficiency peaks at 92% and is higher than charge pu
AME8845BEDS250Z : 3A CMOS LDO
AME8838AEET150Z : High Psrr, 150ma CMOS LDO
AD847JNZ : IC, OP-AMP, 50MHZ, 300V/µs, DIP-8 Specifications: Op Amp Type: General Purpose ; No. of Amplifiers: 1 ; Bandwidth: 50MHz ; Slew Rate: 300V/µs ; Supply Voltage Range: ± 4.5V to ± 18V ; Amplifier Case Style: DIP ; Operating Temperature Range: 0°C to +70°C ; No. of Pins: 8 ; MSL: -
ADUM3210WCRZ-RL7 : Digital Isolator Channel 8-SOIC (0.154", 3.90mm Width); IC DIGITAL ISOLATOR 2CH 8-SOIC Specifications: Number of Channels: 2 ; Package / Case: 8-SOIC (0.154", 3.90mm Width) ; Propagation Delay: 50ns ; Data Rate: 25Mbps ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant
ADM6317AX44ARJ-RL7 : 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO5 Specifications: Package Type: SOT23, Other, MO-178AA, SOT-23, 5 PIN ; Operating Temperature: -40 to 85 C (-40 to 185 F)
ADM6322D34ARJZ-RL7 : 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO5 Specifications: Package Type: SOT23, Other, MO-178AA, SOT-23, 5 PIN ; Operating Temperature: -40 to 85 C (-40 to 185 F)
ADT6402SRJZ-RL7 : Board Mount Temperature Sensors 2.7-5.5V Pin- Selectable Analog Devices (ADI) sensor solutions include MEMS accelerometers, MEMS gyroscopes, MEMS inertial measurement units (IMUs), optical sensors, anisotropic magnetoresistive (AMR) sensors, temperature sensors, and Hall effect sensors. The high performance, discrete components, and plug-in ready solut
ADM869L : 2 A, High-side P-channel Switch With Current Limit And Thermal Shutdown.
DG508A : 8-Channel CMOS Multiplexer. Maxim's DG508A and DG509A are monolithic CMOS analog multiplexers (muxes): the is a single 8-channel (1-of-8) mux, and the is a differential 4-channel (2-of-8) mux. Both devices guarantee break-before-make switching. Maxim guarantees these muxes will not latch up if the power supplies are turned off with the input signals still present. Maxim also guarantees.
ELM440 : 60hz Generator.
HYB3165805AJ-40 : 8m X 8-bit Dynamic RAM. 388 608 words by 8-bit organization 70 °C operating temperature Hyper Page Mode - EDO - operation Performance: -40 tRAC tCAC tAA tRC tHPC RAS access time CAS access time Access time from address Read/write cycle time Hyper page mode (EDO) cycle time ns Single V 0.3V) power supply Low power dissipation: max. 450 active mW ( HYB 3164805AJ/AT(L)-40) max.
KM48C8004B : 8m X 8bit CMOS Dynamic RAM With Extended Data Out. This is a family x 8 bit Extended Data Out Mode CMOS DRAMs. Extended Data Out Mode offers high speed random access of memory cells within the same row. Refresh cycle(4K Ref. or 8K Ref.), access time or -6), package type (SOJ or TSOPII) are optional of this family. All of this family have CAS-before-RAS refresh, RAS-only refresh and Hidden refresh capabilities.
LA7151M : Audio/video Switch For VCR Video Camera Use. The LA7151 and LA7151M are high-performance, dualchannel audio/video switches designed for video camera applications. The LA7151 and LA7151M have a wide bandwidth, low supply current and a large dynamic range, making them ideal for low-power or battery operated equipment. The LA7151 and LA7151M operate from to 12.5V supply and are available in 12-pin.
LA7220M : 3-channel 2-position Electronic Switch For VCR / Audio Use.
LM193A : LM193A/293/A/393/A/2903; Low Power Dual Voltage Comparator;; Package: SOT97-1 (DIP8).
LT1492 : LT1492, 5MHz, 3V/µs, Low Power Single Supply, Dual Precision op Amp. 3V/µ s, Low Power Single Supply, Dual and Quad Precision Op Amps The LT ®1492/LT1493 are dual/quad, low power, single supply precision op amps with 5MHz gain-bandwidth product, 3V/µs slew rate and only 450µA of quiescent supply current per amplifier. With a maximum input offset voltage of only 180µV, the LT1492/LT1493 eliminate trims in most systems.
OPA340 : . SINGLE-SUPPLY, RAIL-TO-RAIL OPERATIONAL AMPLIFIERS MicroAmplifier TM Series RAIL-TO-RAIL INPUT RAIL-TO-RAIL OUTPUT (within 1mV) MicroSIZE PACKAGES WIDE BANDWIDTH: 5.5MHz HIGH SLEW RATE: 6V/µs LOW THD+NOISE: = 1kHz) LOW QUIESCENT CURRENT: 750µA/channel SINGLE, DUAL, AND QUAD APPLICATIONS q DRIVING A/D CONVERTERS q PCMCIA CARDS q DATA ACQUISITION q PROCESS.
OPA541 : . q POWER SUPPLIES ±40V q OUTPUT CURRENT TO 10A PEAK q PROGRAMMABLE CURRENT LIMIT q INDUSTRY-STANDARD PIN OUT q FET INPUT q TO-3 AND LOW-COST POWER PLASTIC PACKAGES APPLICATIONS q MOTOR DRIVER q SERVO AMPLIFIER q SYNCHRO EXCITATION q AUDIO AMPLIFIER q PROGRAMMABLE POWER SUPPLY The is a power operational amplifier capable of operation from power supplies.
TLV2772QDRQ1 : ti TLV2772-Q1, Automotive Catalog 2.7-V High-slew-rate Rail-to-rail Output op Amp W/shutdown.
TS4855 : LouDSPeaker & Headset Driver With Volume Control. LOUDSPEAKER & HEADSET DRIVER WITH VOLUME CONTROL OPERATING FROM VCC 5.0 V SPEAKER: Mono, THD+N @ 1 kHz is 1% Max 1 W into 8 BTL HEADSET: Stereo, THD+N @ 1 kHz is 0.5% Max. 85 mW into 32 BTL VOLUME CONTROL: 32-step digital volume control OUTPUT MODE: Eight different selections Ultra low pop-and-click Low Shutdown Current (0.1 µA, typ.) Thermal Shutdown.
UCC2809-2 : Power. Economy Primary Side Controller. User Programmable Soft Start With Active Low Shutdown User Programmable Maximum Duty Cycle Accessible 5V Reference Undervoltage Lockout Operation 0.4A Source/0.8A Sink FET Driver Low 100µA Startup Current The UCC3809 family of BCDMOS economy low power integrated circuits contains all the control and drive circuitry required for off-line and isolated.
UPC4062 : Dual J-FET Input Low-power Operational Amplifier.