Details, datasheet, quote on part number: IDT7009L15PF
PartIDT7009L15PF
CategoryInterface and Interconnect => Multi-Ports
TitleMulti-Ports
Description128K X 8 Dual-port RAM
CompanyIntegrated Device Technology, Inc.
DatasheetDownload IDT7009L15PF datasheet
Quote
Find where to buy
 
  

 

Features, Applications
Features

True Dual-Ported memory cells which allow simultaneous reads of the same memory location High-speed access Commercial: 15/20ns (max.) Low-power operation IDT7009L Active: 1W (typ.) Standby: 1mW (typ.) Dual chip enables allow for depth expansion without external logic IDT7009 easily expands data bus width to 16 bits or more using the Master/Slave select when cascading more than one device

M/S = VIH for BUSY output flag on Master, M/S = VIL for BUSY input on Slave Interrupt Flag On-chip port arbitration logic Full on-chip hardware support of semaphore signaling between ports Fully asynchronous operation from either port TTL-compatible, single 5V (10%) power supply Available a 100-pin TQFP Industrial temperature range +85C) is available for selected speeds

NOTES: 1. BUSY is an input as a Slave (M/S = VIL) and an output when is a Master (M/S = VIH). 2. BUSY and INT are non-tri-state totem-pole outputs (push-pull).

Description

The is a high-speed x 8 Dual-Port Static RAM. The IDT7009 is designed to be used as a stand-alone 1024K-bit Dual-Port RAM as a combination MASTER/SLAVE Dual-Port RAM for 16-bit-ormore word systems. Using the IDT MASTER/SLAVE Dual-Port RAM approach 16-bit or wider memory system applications results in fullspeed, error-free operation without the need for additional discrete logic. This device provides two independent ports with separate control, address, and I/O pins that permit independent, asynchronous access for reads or writes to any location in memory. An automatic power down feature controlled by the chip enables (CE0 and CE1) permit the on-chip circuitry of each port to enter a very low standby power mode. Fabricated using IDT's CMOS high-performance technology, these devices typically operate only1W of power. The IDT7009 is packaged a 100-pin Thin Quad Flatpack (TQFP).

NOTES: 1. All Vcc pins must be connected to power supply. 2. All GND pins must be connected to ground. 3. Package body is approximately 1.4mm. 4. This package code is used to reference the package diagram. 5. This text does not indicate orientation of the actual part marking.

Left Port CE0L, CE1L R/WL OEL - I/O7L SEML INTL BUSYL Right Port CE0R, CE1R R/WR OER - I/O7R SEMR INTR BUSYR M/S VCC GND Names Chip Enables Read/Write Enable Output Enable Address Data Input/Output Semaphore Enable Interrupt Flag Busy Flag Master or Slave Select Power Ground

Symbol VTERM(2) Rating Terminal Voltage with Respect to GND Temperature Under Bias Storage Temperature DC Output Current Commercial & Industrial to +7.0 Military to +7.0 Unit V

Symbol VCC Parameter Supply Voltage Ground Input High Voltage Input Low Voltage Min. Typ. 5.0 0

NOTES: 1. Stresses greater than those listed under ABSOLUTE MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. 2. VTERM must not exceed Vcc + 10% for more than 25% of the cycle time or 10ns maximum, and is limited < 20mA for the period of VTERM > Vcc + 10%.

NOTES: 1. VIL > -1.5V for pulse width less than 10ns. 2. VTERM must not exceed Vcc + 10%.

Param eter (1) Inp ut Cap acitanc e Outp ut Cap acitanc e Conditions 3d V OUT 3d V Max. 9 10 Unit pF

NOTES: 1. This parameter is determined by device characterization but is not production tested. 2. 3dV represents the interpolated capacitance when the input and output signals switch from 3V or from to 0V.

NOTES: 1. Industrial Temperature: for specific speeds, packages and powers contact your sales office. 2. This is the parameter TA. This is the "instant on" case temperature.


 

Related products with the same datasheet
IDT7009
IDT7009L20PF
IDT7009L20PFG
IDT7009L15PF8
IDT7009L15PFG
IDT7009L15PFG8
IDT7009L20PF8
IDT7009L20PFGI
IDT7009L20PFGI8
IDT7009L20PFI8
Some Part number from the same manufacture Integrated Device Technology, Inc.
IDT7009L20PF 128K X 8 Dual-port RAM
IDT70121 Dual-port RAM Master: 2kx9
IDT70121L High-speed 2k X 9 Dual-port Static RAM With Busy & Interrupt
IDT70121L-25 Dual-port RAM Master: 2kx9
IDT70121S High-speed 2k X 9 Dual-port Static RAM With Busy & Interrupt
IDT70121S-25 Dual-port RAM Master: 2kx9
IDT70125L High-speed 2k X 9 Dual-port Static RAM With Busy & Interrupt
IDT70125L-25 Dual-port RAM Master: 2kx9
IDT70125S High-speed 2k X 9 Dual-port Static RAM With Busy & Interrupt
IDT70125S-25 Dual-port RAM Master: 2kx9
IDT7014 4K X 9 Dual-port RAM
IDT7014S High-speed 4k X 9 Dual-port Static RAM
IDT7014S-12 4K X 9 Dual-port RAM
IDT7014S12J High-speed 4k X 9 Dual-port Static RAM
IDT7015 8K X 9 Dual-port RAM
IDT7015L High-speed 8k X 9 Dual-port Static RAM
IDT7015L-12 8K X 9 Dual-port RAM
IDT7015L12GB High-speed 8k X 9 Dual-port Static RAM
IDT7015L12J 8K X 9 Dual-port RAM
IDT7015L12JB High-speed 8k X 9 Dual-port Static RAM
IDT7015L12PF 8K X 9 Dual-port RAM

IDT70V9159L7PFI : 8K X 9 Sync,3.3V Dual-port RAM, Pipelined/flow-through

IDT7134L55J : Multi-Ports 4K X 8 Dual-port RAM

IDT7164L20DB : 8K X 8 Static RAM

IDT72V255LA : 3.3v CMOS Supersync Fifo(tm) 8,192x18; 16,384x18

ICS8535BGI-01LF : 85354 SERIES, 2 LINE TO 1 LINE MULTIPLEXER, COMPLEMENTARY OUTPUT, QCC16 Specifications: Output Characteristics: Complementary Output ; Supply Voltage: 2.5V ; Package Type: 3 X 3 MM, 0.95 MM HEIGHT, MO-220, VQFN-16 ; Number of Pins: 16 ; Inputs: 2 ; Operating Temperature: -40 to 85 C (-40 to 185 F)

ICS87339AM-01T : 87332 SERIES, LOW SKEW CLOCK DRIVER, 1 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO8 Specifications: Device Type: Clock Driver ; Package Type: Surface Mount, SOIC, 3.90 X 4.90 MM, 1.37 MM HEIGHT, MS-012, SOIC-8 ; Supply Voltage: 2.38 to 3.8 volts ; Frequency: 500 MHz ; Operating Temperature: -40 to 85 C (-40 to 185 F)

IDT7008S20PF8 : 64K X 8 DUAL-PORT SRAM, 15 ns, PQCC84 Specifications: Memory Category: SRAM Chip ; Density: 524 kbits ; Number of Words: 64 k ; Bits per Word: 8 bits ; Package Type: 1.15 X 1.15 INCH, 0.17 INCH HEIGHT, PLASTIC, LCC-84 ; Pins: 84 ; Logic Family: CMOS ; Supply Voltage: 5V ; Access Time: 15 ns ; Operating Temperature: 0 to 70 C (32 to 158

M2006-02I690.5692 : PLL BASED CLOCK DRIVER, 2 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), CQCC36 Specifications: Device Type: Clock Driver ; Package Type: Surface Mount, 9 X 9 MM, CERAMIC, LCC-36 ; Supply Voltage: 3.14 to 3.46 volts ; Frequency: 700 MHz ; Operating Temperature: 0.0 to 70 C (32 to 158 F) ; Features / Standards: RoHS, Lead-Free

7204L15TDG : 4K X 9 OTHER FIFO, 15 ns, CDIP28 Specifications: Memory Category: FIFO ; Density: 37 kbits ; Number of Words: 4 k ; Bits per Word: 9 bits ; Package Type: DIP, GREEN, CERAMIC, DIP-28 ; Pins: 28 ; Logic Family: CMOS ; Supply Voltage: 5V ; Access Time: 15 ns ; Cycle Time: 25 ns ; Operating Temperature: 0 to 70 C (32 to 158 F)

7205L35TPG : 8K X 9 OTHER FIFO, 35 ns, CDIP28 Specifications: Memory Category: FIFO ; Density: 74 kbits ; Number of Words: 8 k ; Bits per Word: 9 bits ; Package Type: DIP, GREEN, CERAMIC, DIP-28 ; Pins: 28 ; Logic Family: CMOS ; Supply Voltage: 5V ; Access Time: 35 ns ; Cycle Time: 45 ns ; Operating Temperature: 0 to 70 C (32 to 158 F)

72V845L15PF8 : 4K X 18 BI-DIRECTIONAL FIFO, 6.5 ns, PQFP128 Specifications: Memory Category: FIFO ; Density: 74 kbits ; Number of Words: 4 k ; Bits per Word: 18 bits ; Package Type: TQFP, TQFP-128 ; Pins: 128 ; Logic Family: CMOS ; Supply Voltage: 3.3V ; Access Time: 6.5 ns ; Cycle Time: 10 ns ; Operating Temperature: 0 to 70 C (32 to 158 F)

858011AKLF : 858011 SERIES, LOW SKEW CLOCK DRIVER, 2 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), QCC16 Specifications: Device Type: Clock Driver ; Package Type: Surface Mount, 3 X 3 MM, 0.95 MM HEIGHT, ROHS COMPLIANT, MO-220, VFQFN-16 ; Supply Voltage: 2.38 to 3.63 volts ; Operating Temperature: -40 to 85 C (-40 to 185 F) ; Features / Standards: RoHS, Lead-Free

 
0-C     D-L     M-R     S-Z