Positive And Negative Regulators In One Package Hermetic 5-Pin Metal Package, JEDEC MO-078AA Isolated Case Output Voltages 5V, 12V and 15V; Other Voltages Available Output Voltages Set Internally To ±2.0% Built-In Thermal Overload Protection Short Circuit Current Limiting Product Is Available Screened To MIL-S-19500, TX, TXV And S Levels

This series of products offers a positive and a negative fixed voltage regulator in one hermetically sealed, 5 PIN package whose outline is similar to the industry standard TO-247 package. With heat sinking, they can regulate over 1.5 Amp of output current per device. Standard voltages are 5V, 12V and 15V. Other voltages are available upon request. Output voltages are internally trimmed ±2.0% of nominal voltage. These devices are ideally suited for Military applications where small size and high reliability are required. To order, use the following Omnirel part numbers to determine the required output voltage of each regulator within one package. Omnirel Part Number OM7508SC OM7509SC Output Voltages Positive Negative +15V -15V

Parameter Output Voltage Symbol VOUT VRLINE VIN TA 125°C (unless otherwise specified) Min. 4.92 Max. 5.15 5 Unit mV mA Test Conditions = 25°C VIN to 20V Line Regulation (Note 1) VIN to 12V VIN to 20V

Standby Current Drain ISCD DISCD (Line) DISCD (Load) VDO IO (pk) IDS DVIN DVOUT Output Noise Voltage (Note 3) Long Term Stability (Note 3) DVOUT = 1000 hrs. = 25°C, DVOUT = 25°C VIN to 1000mA VIN to 20V

Standby Current Drain Change With Line Standby Current Drain Change With Load Dropout Voltage Peak Output Current Short Circuit Current (Note 2) Ripple Rejection

ISCD DISCD (Line) DISCD (Load) VDO IO (pk) IDS DVIN DVOUT NO DVOUT Dt DVOUT = 25°C VIN to 1000mA VIN to 30V

Standby Current Drain Change With Load Dropout Voltage Peak Output Current Short Circuit Current (Note 2) Ripple Rejection

Notes: 1. Load and Line Regulation are specified at a constant junction temperature. Pulse testing with low duty cycle is used. Changes in output voltage due to heating effects must be taken into account separately. 2. Short Circuit protection is only assured up to VIN 3. If not tested, shall be guaranteed to the specified limits. The denotes the specifications which apply over the full operating temperature range.

ISCD DISCD (Line) DISCD (Load) VDO IO (pk) IDS DVIN DVOUT NO DVOUT = 25°C, DVOUT = 25°C VIN to 1000mA VIN to 30V

ISCD DISCD (Line) DISCD (Load) VDO IO (pk) IDS DVIN DVOUT NO DVOUT Dt DVOUT = 25°C VIN to 1000mA VIN to -20V

Notes: 1. Load and Line Regulation are specified at a constant junction temperature. Pulse testing with low duty cycle is used. Changes in output voltage due to heating effects must be taken into account separately. 2. Short Circuit protection is only assured up to VIN =+35V, positive regulator;.VIN = -35V, negative regulator. 3. If not tested, shall be guaranteed to the specified limits. The denotes the specifications which apply over the full operating temperature range.