|Category||RF & Microwaves => Couplers|
|Description||E-Series SMT 75 Ohm 20 DB Coupler 5 - 1000 MHZ|
|Datasheet||Download MACPES0050 datasheet
Low Intermod Distortion Coupling 20db Typical Surface Mount Tape and Reel Packaging available
M/A-COM's is a high performance 75 Ohm Coupler, a SM-55 low cost, surface mount package. Ideally suited for high volume CATV applications.Input Return Loss Output Return Loss
Please Note that the photograph above indicates package shape only, unit may be wired differently. 1611 A
Specifications subject to change without notice. n North America: Tel. (800) 366-2266, Fax 618-8883 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. 300 020 Visit www.macom.com for additional data sheets and product information.Function Input Output Coupled Ground Not Connected External 75 Ohms Pin No.
Parameter RF Power DC Current Operating/Storage Temperature Absolute Maximum to +85°C
Specifications subject to change without notice. n North America: Tel. (800) 366-2266, Fax 618-8883 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. 300 020 Visit www.macom.com for additional data sheets and product information.
|Some Part number from the same manufacture M/A-COM, Inc.|
|MADA2030G DC-2 Ghz, 5-Bit GAAS Attenuator|
|MADCSM0001 Dual-Band/Triple-Mode Downconverter, 869 - 893 MHZ And 1930 - 1990 MHZ|
|MADCSM0011 Dual Mode Cellular Downconverter, 869 - 893 MHZ|
|MADCSM0012 PCS LNA/Downconverter, 1800 - 2000 MHZ|
|MADRCC0002 Dual Linear Driver For Vector Modulators|
|MAFLES0083 E-Series (DOCSIS) Catv Diplexer 5 - 1000 MHZ|
|MAFRIN0034 Miniature Surface Mount Dual ISOlators|
|MAFRIN0035 Miniature Surface Mount Dual ISOlators|
|MAFRIN0037 Miniature Drop-in Dual ISOlators|
|MAFRIN0124 Drop-in High Power ISOlators|
|MAFRIN0149 Miniature Surface Mount Circulators|
|MAFRIN0160 Drop-In, High Power, Low Intermod ISOlators|
|MAFRIN0203 Miniature Surface Mount ISOlators|
|MAMDCC0002 Vector Modulator, 1.805 to 1.88 GHZ (DCS) And 1.93 to 1.99 GHZ (PCS)|
|MAMDCC0005 Vector Modulator, 925 to 960 MHZ|
AS195-300 : Phemt GAAS ic High Power SP5T Switch. 5 Symmetric RF Paths Positive Voltage Control High IP3 Excellent Harmonic Performance Handles GSM Power Levels Available x 4 mm) Package The is a reflective SP5T switch. is an ideal switch for higher power applications. It can be used for GSM dual-band handset applications where both low loss, low current and small size are critical parameters. Parameter.
AT002D8-31 : Digital Attenuator. GAAS 4 Bit Digital Attenuator. s Low DC Power Consumption s Attenuation 1 dB Steps 15 dB with High Accuracy s 14 Lead Hermetic Surface Mount Package s Capable of Meeting MIL-STD Requirements6 The is an MMIC FET digital attenuator consisting of four monolithic attenuators with an LSB 1 dB and a total attenuation 15 dB with all attenuators connected. This attenuator is recommended.
CHP2085 : S-band Phase Shifter / Switch. The is a S-band monolithic 5 bits phase shifter / switch. The circuit is manufactured with a standard MESFET process : via holes through the substrate, air bridges and electron beam gate lithography. It is supplied in chip form. Frequency range 3.4GHz 11.25° phase quantization 27dB switch isolation Chip size x 0,1mm Tamb = +25°C Symbol Fop PHIpp Il Is Parameter.
DS52-0005 : Low Cost 2-Way SMT Power Splitter/divider 1700- 1900 MHZ. Small Size and Low Profile Industry Standard SOIC-8 SMT Plastic Package Superior Repeatability Excellent Amplitude Balance: 0.05 dB Typical Excellent Insertion Loss: 0.3 dB Typical Low Cost DCS-1800 Frequency Coverage M/A-COM's is an IC-based monolithic power divider in a low cost SOIC-8 plastic package. This 2-way power splitter is ideally suited for applications.
EMDC-17-8-75 : E-Series SMT 75 Ohm 17 DB Coupler 5 - 1000 MHZ. Coupling 17db Typical Surface Mount Tape and Reel Packaging available M/A-COM's a 75 Ohm Coupler, in a low cost, surface mount package.The EMDC-17-8-75 is ideally suited for use in high volume CATV applications. *Notes: 1.Core is coated with Paralyene C, 0.005" thick minimum. 2.Wire is heavy poly-nylon coated, rated to 180C. M/A-COM Division of AMP Incorporated.
HH-109 : Hybrid Junction, 5 - 200 MHZ. - 180° Hybrid with High Isolation Usable from 500 KHz - 500 MHz MIL-STD-202 Screening Available 3 dB Hybrids are ideal for dividing a signal into two signals of equal amplitude and a constant or 180° phase differential and for Quadrature combining or performing summation/differential combining. Parameter Insertion Loss Isolation Amplitude Balance VSWR.
IZY2PD-64 : Power Splitter. Power Splitter. C. 1. Isolation specified to 0.004 MHz Insertion loss, Isolation specified to -20°C from to 0.004 MHz When only for M range given, applies to entire frequency range. At low range frequency band (fL to 10 fL), linearly derate maximum input power by 13 dB. Denotes 75 Ohm model, for coax connector models 75 Ohm BNC connectors are standard. Available only.
LG30 : Drivers. TO-8 Thin-film Linearizer For The G30. TO-8 THIN-FILM LINEARIZER FOR THE G30 WIDE TEMPERATURE OPERATION YIELDS LINEAR ATTENUATION (dB) FOR LINEAR CONTROL VOLTAGE -V +V Vcon Combination of LG30 and -V +V Vcon Control Voltage 0 V (Max. Attenuation) 6 mA Control Voltage 15 V (Min. Attenuation) 12 mA Storage Temperature Max. Case Temperature Max. DC Voltage "S" Series Burn-in Temperature (Case).
MA02303GJ : LNAs. RF Power Amplifier ic For 2.4 GHZ Ism. Perfect for 2.4 GHz Cordless DECT (WDECT) Single Positive Supply Power Added Efficiency As High As 55 Percent = +43 dBm Output Power 26.5 dBm 3.3 V Output Power 28.5 dBm V 100 Percent Duty Cycle to 2600 MHz Operation 8 Pin MSOP Full Downset Plastic Package Operates Over Wide Ranges of Supply Voltage Self-Aligned MSAG®-Lite MESFET Process The an RF power.
MAAPGM0045-DIE : 11.5-15 GHZ 2.0 Watt Amplifier Mmic. 2.0 Watt Saturated Output Power Level 11.5-15.0 GHz Operation Variable Drain Voltage (4-10V) Operation Self-Aligned MSAG ® MESFET Process The 2.0 W power amplifier with onchip bias networks. This product is fully matched to 50 ohms on both the input and output. It can be used as a power amplifier stage as a driver stage in high power applications. Each.
TML9017 : Frequency Range (MHz) Min = 10 ;; Frequency Range (MHz) Max = 1000 ;; Gain (dB) TYP = 11.5 ;; Gain (dB) Min = 9.5 ;; Input Power Limiting Range (dBm) = 0 to +20 ;; Output Level Saturated (dBm) TYP = +11 ;; Output Level Saturated (dBm) Min = +7 ;; Output Power Flatness (dB) Max = 1.0 ;; Noise Figure (dB) Max = 7.5 ;; VSWR In/out Max = 2.2:1/2.0:1 ;; Power.
UPC8128TB : Simmic Low Current Amplifiers For Cellular/cordless Telephones. SILICON RFIC LOW CURRENT AMPLIFIER FOR UPC8128TB CELLULAR/CORDLESS TELEPHONES LOW CURRENT CONSUMPTION: Icc = 2.8 mA, TYP 3.0 V HIGH EFFICIENCY: = -4 dBm, TYP = 1 GHz POWER GAIN: = 12.5 dB, TYP = 1 GHz OPERATING FREQUENCY: 100 MHz to 1900 MHz (Output port LC matching) EXCELLENT ISOLATION: ISOL 39 dB TYP = 1 GHz HIGH DENSITY SURFACE MOUNTING: 6 pin super.
ML5824 : The ML5824 Transverter provides all of the additional circuitry necessary to upgrade an existing 2.4GHz product for use at 5.8GHz. The ML5824 contains a PLL-based fixed local oscillator, upconvert and downconvert mixers, LNA, PA predriver, filters and buffers. It was designed to enable manufacturers of 2.4GHz wireless products such as Bluetooth, 802.11b,.
AD8339 : DC to 50 MHz, Quad I/Q Demodulator and Phase Shifter 1 The AD8339 is a quad I/Q demodulator configured to be driven by a low noise preamplifier with differential outputs. It i optimized for the LNA in the AD8332/AD8334/AD8335 family of VGAs. The part consists of four identical I/Q demodulators with a 4¡Á local oscillator (LO) input that divides this.
PE43501 : 50-ohm, 5-bit RF Digital Attenuator 0.25 DB Steps To 7.75 DB, DC ? 6.0 GHz Featuring HaRP? Technology Enhancements The PE43501 is a HaRP?-enhanced, high linearity, 5-bit RF Digital Step Attenuator (DSA). This highly versatile DSA covers a 7.75 dB attenuation range in 0.25 dB steps. The Peregrine 50? RF DSA provides a serial-addressable CMOS control.
RFPA2089 : InGaP HBT Power Amplifier 0.25W, 50MHz To 2700MHz The RFPA2089 is a single-stage InGaP HBT power amplifier specifically designed for wireless infrastructure applications. It offers high-gain linear operation at a comparably low DC power making it ideal for next generation radios requiring high efficiency. Its external matching allows for use across.