Details, datasheet, quote on part number: MAX2622EVKIT
PartMAX2622EVKIT
CategoryUnsorted
DescriptionEvaluation Kits
CompanyMaxim Integrated Products
DatasheetDownload MAX2622EVKIT datasheet
Quote
Find where to buy
 
  

 

Features, Applications

The MAX2622/MAX2623/MAX2624 evaluation kits (EV kits) simplify evaluation of the MAX2622/MAX2623/ MAX2624 VCOs. These kits enable testing of the devices' RF performance and require no additional support circuitry. The signal output uses an SMA connector to facilitate the connection to RF test equipment.

Features

o Easy Evaluation to +5.5V Single-Supply Operation o RF Output Matched 50 o All Critical Peripheral Components Included

DESIGNATION QTY R1, R2 OUT JU1 U1 DESCRIPTION 220pF 5% ceramic capacitors (0603) Murata GRM39COH0G221J50 0 resistor 0.1F 5% ceramic capacitor (0603) Taiyo Yuden 1k 5% resistors (0603) SMA connector (PC edge mount) EFJohnson 142-0701-801 or Digi-Key J502-ND 3-pin headers or MAX2624EUA PART MAX2623EVKIT MAX2624EVKIT

TEMP. RANGE to +85C IC-PACKAGE 8 MAX 8 MAX 8 MAX

This section lists the recommended test equipment to verify operation of the It is intended as a guide only, and some substitutions are possible. A two-channel power supply +5.5V An ammeter (optional) An RF spectrum analyzer (HP 8561E, for example) that covers the operating frequency range of the MAX2622/MAX2623/MAX2624, as well as a few harmonics A 50 SMA cable

SUPPLIER Murata Electronics Taiyo Yuden PHONE 800-831-9172 408-573-4150 FAX 814-238-0490 408-573-4159

This section provides a step-by-step guide to the functions and operation of these EV kits. 1) Connect a DC supply set to +3V (through an ammeter, if desired) to the VCC and GND terminals on the EV kit. 2) Apply +3V to the SHDN control input. 3) Turn on the DC supply. The supply current should read about 8mA. 4) Connect the VCO output to a spectrum analyzer with a 50 coaxial cable. 5) Apply a variable DC voltage to the TUNE input +2.4V). 6) Check fMIN and fMAX on the spectrum analyzer by varying the tuning voltage. 7) Check the output power level (-3dBm typ).

NOTE: Please indicate that you are using the or MAX2624 when contacting these component suppliers.

The MAX2622/MAX2623/MAX2624 EV kits are fully assembled and factory tested. Follow the instructions in the Connections and Setup section for proper device evaluation.

For free samples and the latest literature, visit www.maxim-ic.com or phone 1-800-998-8800. For small orders, phone 1-800-835-8769.

Figure MAX2622//MAX2623/MAX2624 EV Kits Component Placement Guide--Component Side

Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.

2 _____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA Maxim Integrated Products Printed USA is a registered trademark of Maxim Integrated Products.


 

Related products with the same datasheet
MAX2623EVKIT
MAX2624EVKIT
Some Part number from the same manufacture Maxim Integrated Products
MAX2623 Fully Monolithic 900mhz Sige Vco in 8-pin Umax
MAX2623EVKIT Evaluation Kits
MAX2624 Fully Monolithic 900mhz Sige Vco in 8-pin Umax
MAX2624EVKIT Evaluation Kits
MAX262A P Programmable, Universal Switched Capacitor Filter
MAX262BENG Microprocessor Programmable Universal Active Filters
MAX262BM P Programmable, Universal Switched Capacitor Filter
MAX263 -
MAX2630 VHF-to-microwave, +3v, General-purpose Amplifiers
MAX2632EUK-T
MAX2633
MAX263AC -
MAX263ACPI VHF-to-microwave, +3v, General-purpose Amplifiers
MAX263AM -
MAX263AMJI VHF-to-microwave, +3v, General-purpose Amplifiers
MAX263BC -
MAX263BCPI VHF-to-microwave, +3v, General-purpose Amplifiers
MAX263BM -
MAX263BMJI VHF-to-microwave, +3v, General-purpose Amplifiers
MAX263C -
MAX2640 400mhz to 2500mhz Sige Ultra-low-noise Amplifiers

DS1870E-010 : Ldmos RF Power-amplifier Bias Controllerthe DS1870 is a Dual-channel Bias Controller Targeted Toward Class ab Ldmos RF Power-amplifier Applications. It Uses Lookup Tables (LUTs) to Control 256-position Potentiometers Based on The Amplifier's Temperature And Drain Voltage or Current. With Its I

MAX4525C : Low-Voltage, Single-supply Multiplexer And Switch

MAX6318MHUK34CZ-T : 5-Pin P Supervisory Circuits With Watchdog And Manual Reset The MAX6316MAX6322 family of microprocessor (P) supervisory circuits monitors power supplies and microprocessor activity in digital systems. It offers several combinations of push/pull, open-drain, and bidirectional (such as Motorola 68

MAX6483BL19BD4-T : 300mA LDO Linear Regulators With Internal Microprocessor Reset Circuit The MAX6469MAX6484 are low-dropout linear regulators with a fully integrated microprocessor reset circuit. Each is available with preset output voltages from +1.5V to +3.3V in 100mV increments and delivers up to 300mA of load c

MAX6441KAOSWD7+T : Pmic - Battery Management Integrated Circuit (ics) Tape & Reel (TR) 1 V ~ 5.5 V; IC BATTERY MON DUAL SOT23-8 Specifications: Battery Chemistry: Alkaline, Li-Ion, NiCd, NiMH ; Function: Battery Monitor ; Package / Case: SOT-23-8 ; Packaging: Tape & Reel (TR) ; Operating Temperature: -40C ~ 85C ; Voltage - Supply: 1 V ~ 5.5 V ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant

MAX1456CWI+ : Interface - Sensor And Detector Interface Integrated Circuit (ics) Signal Conditioner Tube 2.6mA; IC SGNL CONDITIONER 28-SOIC Specifications: Package / Case: 28-SOIC (0.295", 7.50mm Width) ; Packaging: Tube ; Type: Signal Conditioner ; Interface: Serial ; Current - Supply: 2.6mA ; Input Type: Analog ; Output Type: Analog ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant

MAX6382XR25D2 : SC70/DFN, Single/Dual Low-Voltage, Low-Power P Reset Circuits The MAX6381MAX6390 microprocessor (P) supervisory circuits monitor power-supply voltages from +1.8V to +5.0V while consuming only 3A of supply current at +1.8V. Whenever VCC falls below the factory-set reset thresholds, the reset ou

MAX6484BL16AD2 : FIXED/ADJUSTABLE POSITIVE LDO REGULATOR, PBGA6 Specifications: Regulator Type: Low Dropout ; Output Polarity: Positive ; Output Voltage Type: Fixed, Adjustable / Variable ; Package Type: Other, 3 X 3 MM, UCSP-6 ; Life Cycle Stage: ACTIVE ; Output Voltage: 1.23 to 5 volts ; IOUT: 0.3000 amps

MAX776ESA-T : SWITCHING CONTROLLER, 300 kHz SWITCHING FREQ-MAX, PDSO8 Specifications: Configuration / Function: Buck-Boost ; Package Type: SOIC, Other, 0.150 INCH, PLASTIC, SOIC-8 ; Life Cycle Stage: ACTIVE ; VIN: 5 volts ; fsw: 300 kHz ; Operating Temperature: -40 to 85 C (-40 to 185 F)

Same catergory

AT43DK312A : Usb Hub Development Kit. Instant Prototype With the AT43312A Hub Controller Reduce Design Cycle Reduce System Debugging Simplify Component Selection Avoid Typical Design Problems The AT43DK312A comes with everything designers need to develop a full-featured USB Hub. To eliminate typical prototyping hassles, a fully populated stand-alone hub is included. Designers can take the stand-alone.

CD4060BDMSR : Space Applications. Radiation Hardened CMOS 14 Stage Ripple-carry Binary Counter/divider And Oscillator.

DV2954S1H : Enhanced Charge Management With Integrated PWM Switching Controller. Control of On-Board PNP Switch-Mode Regulator with High-Side Current Sensing bq2954 fast-charge control evaluation and development, based on switching buck converter with high-side battery-current sensing On-board configuration for fast charge or 4 Li-Ion cells Charge termination by maximum voltage, selectable minimum current, or maximum time-out Constant.

DVME-613 : Boards->Data Acquisition. 16 single-ended or 8 differential analog input channels or 16-bit A/D resolution Isolation to 500V On-board programmable gain amplifier and start timer 8 in and 8 out discrete digital lines Programmable vectored VME interrupt Simple programming for any operating system or language Designed for industrail data acquisition, process control, and factory.

Edge737 : Measurement->Parametric Measurement. Per-pin Precision Measurement Unit.

KBA0401A0M : MCP->Customized. = KBA0401A0M 64M Bit (4Mx16) Four Bank Nor Flash Memory *2 /32M Bit (2Mx16) Utram / 8M Bit (512Kx16) SRAM ;; Combination = 128M NOR(64Mx2)+32M UtRAM+8M SRAM ;; Speed = Nor(85ns),NAND(10us,50ns),UtRAM(85ns) ;; Package = 80TBGA ;; PKG Size(mm) = 10x11x1.4 ;; Production Status = Mass Production ;; Comments = 4Stack.

KIA339F : Comparator. = Quad Voltage Comparator ;; Package = FLP-14.

MAX+PLUSII : Programmable Logic Development System & Software.

MAX132EVKIT : Evaluation Kit: Max132.

MAX4429MJA/883B : Military/Aerospace->Military Standard. Power MOSFET Driver. POWER MOSFET DRIVER Generic Number MAX4429M(x)/883B MAX4420M(x)/883B Circuit Function Inverting Power MOSFET Driver Noninverting Power MOSFET Driver Case Outline(s). The case outlines shall be designated in Mil-Std-1835 and as follows: Outline Letter CDIP2-T8 CQCC1-N20 Case Outline Package Code 8 LEAD CERDIP J8 20 Leadless Carrier LCC Absolute Maximum.

MAX641AMJA/883B : Military/Aerospace->Military Standard. Fixed Output, 10w CMOS,step-up Switching Regulator.

MAX774IRGEVKIT : Isdn, Ring-tone, Power-supply Evaluation Kit For Max774/max775/max776.

MCB-24/50 : Boards->Motor Control. OVERVIEW The MCB-24 (23k SPS) and MCB-50 (50k SPS) are low-cost OEM motor control boards that integrate quickly into new or retrofit product designs. On-board non-volatile memory allows application sequences of high level hardware, or keyboard "Go" commands. Commands issued via the line editor permit precise control with position trigger, loop on ports.

MultiScan/1200 : Boards->Data Acquisition. Measures thermocouples, volts, & RTDs to 960 channels/s Accepts optional scanning modules for measuring thermocouples, RTDs, or DC volts Expandable to 992 channels Measures isolated temperature, DC volts, AC volts, & waveforms in one compact instrument Scans thermocouples & DC volts to 147 channels/s Single-channel burst mode for digitizing waveforms.

MX7524UQ/883B : Military/Aerospace->Military Standard. CMOS Buffered, Multiplying 8-bit D/A Converter.

 
0-C     D-L     M-R     S-Z