Details, datasheet, quote on part number: DS8921MX
PartDS8921MX
CategoryInterface and Interconnect => RS-422/RS-423
DescriptionDS8921 - Differential Line Drivers And Receiver Pair, Package: Soic Narrow, Pin Nb=8
CompanyNational Semiconductor Corporation
DatasheetDownload DS8921MX datasheet
Cross ref.Similar parts: DS8921M/NOPB, DS14185, DS1487, DS16F95A, DS16F95QML, DS36276, DS36277, DS3695, DS3695A, DS3695AT
Quote
Find where to buy
 
  

 

Features, Applications

The DS8921, DS8921A are Differential Line Driver and Receiver pairs designed specifically for applications meeting the ST506, ST412 and ESDI Disk Drive Standards. In addition, these devices meet the requirements of the EIA Standard RS-422. The DS8921, DS8921A receivers offer an input sensitivity 200 mV over 7V common mode operating range. Hysteresis is incorporated (typically 70 mV) to improve noise margin for slowly changing input waveforms. The DS8921, DS8921A drivers are designed to provide unipolar differential drive to twisted pair or parallel wire transmission lines. Complementary outputs are logically ANDed and provide an output skew 0.5 ns (typ.) with propagation delays of 12 ns. The DS8921, DS8921A are designed to be compatible with TTL and CMOS.

Features

12 ns typical propagation delay Output skew 0.5 ns typical Meet the requirements of EIA Standard RS-422 Complementary Driver Outputs High differential or common-mode input voltage ranges 0.2V receiver sensitivity over the input voltage range n Receiver input hysteresis-70 mV typical n DS8921AT industrial temperature operation: to +85C)

Receiver Input VID VTH (MAX) VID VTH (MIN) Open VOUT 0 1 Input 1 0 Driver VOUT 1 0 VOUT 0 1

If Military/Aerospace specified devices are required, please contact the National Semiconductor Sales Office/ Distributors for availability and specifications. Supply Voltage 7V Driver Input Voltage to +7V Output Voltage 5.5V Receiver Output Sink Current 10V Receiver Input Voltage 12V Differential Input Voltage Maximum Package Power Dissipation +25C M Package mW N Package 1160 mW Derate M Package 9.3 mW/C above +25C Derate N Package 5.8 mW/C above +25C

Storage Temperature Range Lead Temperature (Soldering, 4 sec.) Maximum Junction Temperature

Symbol RECEIVER VTH VHYST RIN IIN VOH VOL ISC DRIVER VIH VIL IIL IIH II VCL VOH VOL IOFF |VT| |VT | VT |VOS VOS | ISC ICC VCC = MAX, VOUT = 0V VCC = MAX, VOUT = Logic 0 -30 DRIVER and RECEIVER 0.4 -150 VCC = MAX, VIN = 0.4V VCC = MAX, VIN = 2.7V VCC = MAX, VIN = 7.0V VCC = MIN, IIN -18 mA VCC = MIN, IOH -20 mA VCC = MIN, IOL +20 mA VCC 0V, V OUT mA -7V VCM +7V -7V VCM +7V VIN -7V, +7V (Other Input = GND) VIN = 10V VIN = -10V IOH -400 A IOL 8 mA VCC = MAX, VOUT = 0V Conditions Min Typ Max +200 Units V mA

DIFFERENTIAL CHARACTERISTICS (Figures 3, 5) Symbol TpLH TpHL |TpLHT pHL| Conditions 30 pF (Figures 30 pF (Figures 30 pF (Figures 5, 6)

Note 1: "Absolute Maximum Ratings" are those values beyond which the safety of the device cannot be guaranteed. They are not meant to imply that the device should be operated at these limits. The Table of "Electrical Characteristics" provides conditions for actual device operation. Note 2: All currents into device pins are shown as positive values; all currents out of the device are shown as negative; all voltages are referenced to ground unless otherwise specified. All values shown as max or min are classified on absolute value basis. Note 3: All typical values are VCC = 25C. Note 4: Only one output at a time should be shorted. Note 5: Difference between complementary outputs at the 50% point. Note 6: Differential Delays are defined as calculated results from single ended rise and fall time measurements. This approach in establishing AC performance specifications has been taken due to limitations of available Automatic Test Equipment (ATE). The calculated ATE results assume a linear transition between measurement points and are a result of the following equations:

Where: Tcr = Crossing Point Tra, Trb, Tfa and T fb are time measurements with respect to the input. See Figure 6.


 

Related products with the same datasheet
DS8921AM
DS8921AMX
DS8921AN
DS8921ATJ
DS8921ATM
DS8921ATMX
DS8921ATN
DS8921M
Some Part number from the same manufacture National Semiconductor Corporation
DS8921N DS89C21 - Differential CMOS Line Driver And Receiver Pair, Package: Soic Narrow, Pin Nb=8
DS8922 DS8922 - Tri-state RS-422 Dual Differential Line Drivers And Receiver Pair, Package: Soic Narrow, Pin Nb=16
DS8922A Tri-state Rs-422 Dual Differential Line Drivers And Receiver PaIR (discontinued)
DS8922AM DS8922 - Tri-state RS-422 Dual Differential Line Drivers And Receiver Pair, Package: Soic Narrow, Pin Nb=16
DS8923
DS8923A DS8922 - Tri-state RS-422 Dual Differential Line Drivers And Receiver Pair, Package: Soic Narrow, Pin Nb=16
DS8925 Local Talk Dual Driver/triple Receiver
DS8925M
DS8926
DS8933
DS8934
DS8935 Localtalk Dual Driver/triple Receiver (obsolete)
DS8936
DS8963 MOS-to-led 8-digit Driver
DS8973 9-digit Led Driver (discontinued)
DS89C21 DS89C21 - Differential CMOS Line Driver And Receiver Pair, Package: Soic Narrow, Pin Nb=8
DS89C21MDA
DS89C21TM DS89C21 - Differential CMOS Line Driver And Receiver Pair, Package: Soic Narrow, Pin Nb=8
DS89C386 DS89C386 - Twelve Channel CMOS Differential Line Receiver, Package: SSOP-EIAJ, Pin Nb=48
DS89C387 DS89C387 - Twelve Channel CMOS Differential Line Driver, Package: SSOP-EIAJ, Pin Nb=48
DS89LV21

54ACTQ16244 : Military/Aerospace->FACT ACTQ 54ACTQ16244 - 16-Bit Buffer/line Driver With Tri-state Outputs, Package: Cerpack, Pin Nb=48

COP8CCE9HLQ7 : COP8 Family->Flash COP8CBE9 - 8-Bit CMOS Flash Microcontroller With 8k Memory, Virtual EePROM, 10-Bit A/D And 2.7V to 2.9V Brownout Reset, Package: Llp, Pin Nb=44

DP8522A : Microcmos Programmable 256k/1m/4m Video RAM Controller/drivers (discontinued)

LH0004C : High Voltage Operational Amplifier (discontinued)

LM2588SX-ADJ : LM2588 - Simple Switcher 5A Flyback Regulator With Shutdown, Package: to 263, Pin Nb=7

LM2724ALD : LM2724A - High Speed 3A Synchronous MOSFET Driver, Package: Llp, Pin Nb=8

LM3702XCBP-34 : Microprocessor Supervisory Circuits with Low Line Output and Manual Reset

COP8SGR844Q9 : 8-bit CMOS ROM Based and OTP Microcontrollers with 8k to 32k Memory, Two Comparators and Usart

 
0-C     D-L     M-R     S-Z