Details, datasheet, quote on part number: I74F776A
PartI74F776A
CategoryInterface and Interconnect
DescriptionPi-bus Transceiver
CompanyPhilips Semiconductors (Acquired by NXP)
DatasheetDownload I74F776A datasheet
Quote
Find where to buy
 
  

 

Features, Applications

FEATURES

Drives heavily loaded backplanes with equivalent load impedances down to 10 ohms High drive (100mA) open collector drivers on B port Reduced voltage swing (1 volt) produces less noise and reduces power consumption High speed operation enhances performance of backplane buses and facilitates incident wave switching Compatible with Pi­bus and IEEE 896 Futurebus standards Built­in precision band­gap reference provides accurate receiver thresholds and improved noise immunity Controlled output ramp and multiple GND pins minimize ground bounce Glitch­free power up/power down operation Multiple package options Industrial temperature range available to +85°C)

consumption and a series diode on the drivers to reduce capacitive loading. Incident wave switching is employed, therefore BTL propagation delays are short. Although the voltage swing is less for BTL, so is its receiver threshold, therefore noise margins are excellent. BTL offers low power consumption, low ground bounce, EMI and crosstalk, low capacitive loading, superior noise margin and low propagation delays. This results in a high bandwidth, reliable backplane. The 74F776 A port has TTL 3­state drivers and TTL receivers with a latch function. A separate high­level control voltage input (VX) is provided to limit the A side output level to a given voltage level (such as 3.3V). For 5.0V systems, VX is simply tied to VCC. The 74F776 has a designed feature to control the B output transitions during power sequencing. There are two possible sequencing, They are as follows: LE = low and OEBn = low then the B outputs are disabled until the LE circuitry takes control. Then the B outputs will follow the A inputs, making a maximum of one transition during power­up (or down). LE = high or OEBn = high then the B outputs will be disabled during power­up (or down).

DESCRIPTION

The is an octal bidirectional latched transceiver and is intended to provide the electrical interface to a high performance wired­OR bus. The B port inverting drivers are low­capacitance open collector with controlled ramp and are designed to sink 100mA from 2 volts. The B port inverting receivers have 100 mV threshold region and a 4ns glitch filter. The 74F776 B port interfaces to 'Backplane Transceiver Logic' (BTL). BTL features a reduced to 2V) voltage swing for lower power

ORDER CODE COMMERCIAL RANGE DESCRIPTION VCC 5V ±10%, Tamb N74F776N N74F776A INDUSTRIAL RANGE VCC 5V ±10%, Tamb I74F776N I74F776A PKG DWG #

PINS ­ B7 OEA ­ A7 PNP latched inputs Data inputs with threshold circuitry A output enable input (active high) B output enable inputs (active low) Latch enable input (active low) 3­state outputs DESCRIPTION 74F (U.L.) HIGH/LOW OC/166.7 LOAD VALUE HIGH/LOW 3mA/24mA OC/100mA

­ B7 Open collector outputs Notes to input and output loading and fan out table One (1.0) FAST unit load is defined as: 20µA in the high state and 0.6mA in the low state. OC = Open collector.

SYMBOL OEB0 OEB1 OEA LE VX PINS TYPE I/O Input Enables the A outputs when high Latched when high (a special feature is built in for proper enabling times) Clamping voltage keeping VOH from rising above VX (VX = Vcc for normal use) NAME AND FUNCTION PNP latched input/3­state output (with VX control option) Data input with special threshold circuitry to reject noise/ open collector output, high current drive Enables the B outputs when both pins are low


 

Related products with the same datasheet
I74F776N
Some Part number from the same manufacture Philips Semiconductors (Acquired by NXP)
I74F776N Pi-bus Transceiver
I74F777A Triple Bidirectional Latched Bus Transceiver 3-state Open Collector
I74F786D 4-bit Asynchronous Bus Arbiter
I74F823D Bus Interface Registers
I74F823N
I74F86D 74F86; Quad 2-input Exclusive-OR GATE;; Package: SOT108-1 (SO14), SOT27-1 (DIP14)
I74F86N Quad 2-input Exclusive-OR GATE
ICM7555 ICM7555; General Purpose CMOS Timer
IRF530N IRF530N; N-channel Trenchmos (tm) Transistor;; Package: SOT78 (TO-220AB, SC-46)
IRF540 IRF540; IRF540S; N-channel Trenchmos (tm) Transistor;; Package: SOT78 (TO-220AB, SC-46)
IRF630 IRF630; IRF630S; N-channel Trenchmos (tm) Transistor;; Package: SOT78 (TO-220AB, SC-46)
IRF640 IRF640; IRF640S; N-channel Trenchmos (tm) Transistor;; Package: SOT78 (TO-220AB, SC-46)
IRF730 IRF730; Powermos Transistors Avalanche Energy Rated
IRF830 IRF830; Powermos Transistor Avalanche Energy Rated
IRF840 IRF840; Powermos Transistor Avalanche Energy Rated
IRFP450 Powermos Transistors Avalanche Energy Rated: 500v, 14a
IRFP460 Powermos Transistors Avalanche Energy Rated: 500v, 20a
IRFR220 IRFR220; N-channel Enhancement Mode Field Effect Transistor;; Package: SOT428 (SC-63, D-PAK)
IRFZ24N IRFZ24N; N-channel Enhancement Mode Trenchmos (tm) Transistor;; Package: SOT78 (TO-220AB, SC-46)
IRFZ44N IRFZ44N; N-channel Enhancement Mode Trenchmos (tm) Transistor;; Package: SOT78 (TO-220AB, SC-46)
IRFZ44NS IRFZ44NS; N-channel Enhancement Mode Trenchmos (tm) Transistor

74ALS645AN : Bus Oriented Circuits 74ALS645A/74ALS645A 1; Octal Transceiver (3 State)

ADC0803C : ADC0803/0804; CMOS 8-bit A/D Converters

BUK215-50YT : BUK215-50YT; TopFET High Side Switch SMD Version

P80C32X2BN : P80C31X2/32X2; P80C51X2/52X2/54X2/58X2; P87C51X2/52X2/54X2/58X2; 80C51 8-bit Microcontroller Family 4K/8K/16K/32K ROM/otp 128B/256B RAM Low Voltage (2.7 to 5.5 V), Low Power, High Speed (30/33 MHz)

P83C661X2P87C661X2 : P83C660X2/P87C660X2/P83C661X2/P87C661X2; 80C51 8-bit Microcontroller Family 16KB OTP/ROM, 512B RAM Low Voltage (2.7 to 5.5 V), Low Power, High Speed (30/33 MHZ), Two 400KB I2C Interfaces

PCF8591T : PCF8591; 8-bit A/D And D/A Converter;; Package: SOT162-1 (SO16), SOT38-4 (DIP16)

PMBD352 : Schottky Barrier Double Diode

S1D :

BTA204S-1000C : 3Q Hi-Com Triac Planar passivated high commutation three quadrant triac in a SOT428 (DPAK) surface-mountable plastic package intended for use in circuits where high static and dynamic dV/dt and high dI/dt can occur. This \"series C\" triac will commutate the full rated RMS current at the maximum ra

Same catergory

AV16899DGG : 2.5v/3.3v 18-bit Latched Transceiver With 16-bit Parity Generator/checker 3-state.

DS96177 : Rs-485/rs-422 Differential Bus Repeater. The DS96177 Differential Bus Repeater is a monolithic integrated device designed for one-way data communication on multipoint bus transmission lines. This device is designed for balanced transmission bus line applications and meets EIA Standard RS-485 and RS-422A. The device is designed to improve the performance of the data communication over long.

GL603 : USB Controller. USB+PS/2 Mouse Controller.

HI-8585 : Arinc 429 Line Driver. The HI-8585 and HI-8586 are CMOS integrated circuits designed to directly drive the ARINC 429 bus an 8-pin package. Two logic inputs control a differential voltage between the output pins producing a +10 volt One, a -10 volt Zero, and a 0 volt Null. The CMOS/TTL control inputs are translated to ARINC specified amplitudes using on board zeners. A logic.

IR2151 : Half Bridge Driver, lo in Phase With RT, Programmable Oscillating Frequency, 1.2us Deadtime in a 8-pin Dip Package.

KL5KUSB116 : Usb to Serial. The Kawasaki USB to Serial enables your system to have the capability to communicate between the USB (Universal Serial Bus) port and serial port peripherals. This device meets the USB 1.0/1.1 and standard serial port s. All the advantages of USB are available to peripherals with serial port interface such as plug and play capabilities. With the USB Standard.

LA5314 : Variable Divided Voltage Generator For LCD Use. The is a valiable diveded voltage generator IC for multiple drive of LCD matrix. . Power supply for variable bias LCD matrix. to 1/20 bias by built-in resistances). available Five operational amplifiers to deliver 5 voltage outputs. Low current drain (1.6 mA typ). Miniflat package for miniturization s Parameter Maximum supply voltage Maximum output.

LB1995 : . Three-Phase Brushless Motor Driver for CD-ROM Spindle Drive The is a three-phase brushless motor driver especially suited for CD-ROM spindle motor drives. Current linear drive Control V type amplifier with single side control switching pin Separate power supply for output upper side bias circuit allows low output saturation by boosting this power supply.

LSI53C1010-66 : SCSI integrated circuits. Pci to Dual Channel Ultra160 Scsi Multifunction Controller Technical Manual V2.1 2/01.

M54975 : Bi-cmos 8-bit Serial-input Latched Driver. The is a semiconductor integrated circuit fabricated using Bi-CMOS technology. It contains a serial input to serial/parallel output 8-bit CMOS shift register and CMOS latch as well as bipolar 8-bit parallel-output driver. q Serial input to serial/parallel output q Cascade connections possible through serial output q Latch circuit included for each stage.

PCA9510 : Hot Swappable I2C And Smbus Bus Bufferhot Swappable i C And Smbus Buffers That Allows I/o Card Insertion Into a Live Backplane Without Corrupting The Data And Clock Buses. Control Circuitry Prevents The Backplane From Being Connected to The Card Until a Stop Command or Bus Idle Occurs on The Backplane Without Bus Contention on The Card. When The Connection.

PCA9542A : 2-channel I2C Multiplexer And Interrupt Logicthe PCA9542A is a 1-of-2 Bi-directional Translating Multiplexer, Controlled Via The i C Bus. The Scl/sda Upstream PaIR Fans Out to Two Scx/sdx Downstream Pairs, or Channels. Only One Scx/sdx Channel is Selected at a Time, Determined BY The Contents of The Programmable Control Register. Two Interrupt Inputs,.

HT82M32A : 3/5-Key 3D PS/2 Optical Mouse Controller The HT82M32A/HT82M32B are designed as 2D, 3D 3/5-key PS/2 optical mouse controller. These have serial interface to access the PixArt sensor PAN101, PAN301, PAN3101 or the same compatible series sensor. Refer to the datasheets for detailed register s of the PixArt sensors. Operating voltage: 4.0V~5.5V Microsoft.

DS32506 : The DS32506 (6 port), DS32508 (8 port), and DS32512 (12 port) line interface units (LIUs) are highly integrated, low-power, feature-rich LIUs for DS3, E3, and STS-1 applications. Each LIU port in these devices has independent receive and transmit paths, a jitter attenuator, full-featured pattern generator and detector, performance-monitoring counters,.

DS32ELX0124 : 125 - 312.5 MHz Deserializer With DDR LVDS Parallel Interface The DS32EL0124/ DS32ELX0124 integrates clock and data recovery modules for high-speed serial communication over FR-4 printed circuit board backplanes, balanced cables, and optical fiber. This easy-to-use chipset integrates advanced signal and clock conditioning functions, with an FPGA friendly.

ISL31483E : Fault Protected, Extended CMR, RS-485/RS-422 Transceivers With Cable Invert The ISL3148xE are fault protected, 5V powered differential transceivers that exceed the RS-485 and RS-422 standards for balanced communication. The RS-485 transceiver pins (driver outputs and receiver inputs) are protected against faults up to ±60V. Additionally, the extended.

 
0-C     D-L     M-R     S-Z