Details, datasheet, quote on part number: K1400G
PartK1400G
CategoryDiscrete
DescriptionTeccor® Sidac ;; Package= TO-92 Two-lead
CompanyTeccor Electronics
DatasheetDownload K1400G datasheet
Quote
Find where to buy
 
  

 

Features, Applications

The sidac is a silicon bilateral voltage triggered switch with greater power-handling capabilities than standard diacs. Upon application of a voltage exceeding the sidac breakover voltage point, the sidac switches on through a negative resistance region to a low on-state voltage. Conduction continues until the current is interrupted or drops below the minimum holding current of the device. Teccor's sidacs feature glass-passivated junctions to ensure a rugged and dependable device capable of withstanding harsh environments. Variations of devices covered in this data sheet are available for custom design applications. Consult the factory for more information.

Applications

High-voltage lamp ignitors Natural gas ignitors Gas oil ignitors High-voltage power supplies Xenon ignitors Overvoltage protector Pulse generators Fluorescent lighting ignitors HID lighting ignitors

Features
AC circuit oriented Glass-passivated junctions High surge current capability

di/dt Critical rate-of-rise of on-state current dv/dt Critical rate-of-rise of off-state voltage at rated VDRM; 100 C IBO Breakover current 50/60 Hz sine wave IDRM Repetitive peak off-state current 50/60 Hz sine wave; V = VDRM IH Dynamic holding current 50/60 Hz sine wave; = 100 IT(RMS) On-state RMS current 50/60 Hz sine wave ITSM Peak one-cycle surge current 50/60 Hz sine wave (nonrepetitive) RS Switching resistance R

See 4 for VBO change versus junction temperature. See 4 for IBO versus junction temperature. See 3 for IH versus case temperature. See 5 for test circuit. See 3 for more than one full cycle rating. 90 C for TO-92 Sidac 105 C for TO-202 Sidacs 100 C for 90 C for DO-214 See 5 for clarification of sidac operation. For best sidac operation, the load impedance should be near or less than switching resistance. See package outlines for lead form configurations. When ordering special lead forming, add type number as suffix to part number.

VBO Breakover voltage 50/60 Hz sine wave VDRM Repetitive peak off-state voltage VTM Peak on-state voltage; 1 A

All measurements are made 60 Hz with a resistive load at an ambient temperature +25 C unless otherwise specified. Storage temperature range (TS) to +150 C. The case (TC) or lead (TL) temperature is measured as shown on the dimensional outline drawings in the "Package Dimensions" section of this catalog. Junction temperature range (TJ) to +125 C. Lead solder temperature is a maximum +230 C for 10 s maximum; 1/16" (1.59 mm) from case.

Thermal Resistance (Steady State) RJC [RJA] C/W (TYPICAL) *

* See Electrical Specification Note (6). RJA for TO-202 Type 23 and Type is 70 C/Watt. Mounted 1 cm2 copper foil surface; two-ounce copper foil

Peak Surge (Non-repetitive) On-state Current [ITSM] Amps

SUPPLY FREQUENCY: 60 Hz Sinusoidal LOAD: Resistive RMS ON-STATE CURRENT: IT RMS Maximum Rated Value at Specified Junction Temperature

Figure E9.2 Normalized DC Holding Current versus Case/Lead Temperature

Notes: 1) Blocking capability may be lost during and immediately following surge current interval. 2) Overload may not be repeated until junction temperature has returned to steady-state rated value.

Figure E9.1 Peak Surge Current versus Surge Current Duration

 

Related products with the same datasheet
K0900G
K0900S
K1050E70
K1050G
K1050S
K1100E70
K1100G
K1100S
K1200E70
K1200G
K1200S
K1300E70
Some Part number from the same manufacture Teccor Electronics
K1400S Teccor® Sidac ;; Package= TO-92 Two-lead
K1500 Sidac (95 - 330v)
K1500E70 Teccor® Sidac ;; Package= TO-92 Two-lead
K2000 Sidac (95 - 330v)
K2000E70 Teccor® Sidac ;; Package= TO-92 Two-lead
K2200 Sidac (95 - 330v)
K2200E70 Teccor® Sidac ;; Package= TO-92 Two-lead
K2400 Sidac (95 - 330v)
K2400E70 Teccor® Sidac ;; Package= TO-92 Two-lead
K2500 Sidac (95 - 330v)
K2500E70 Teccor® Sidac ;; Package= TO-92 Two-lead
K3000 Sidac (95 - 330v)
K3000F1 Teccor® Sidac ;; Package= TO-92 Two-lead
L2004D3 Teccor® Sensitive Triac ;; Package= TO-252AA SM D-pak
L2004D512V Thyristor Product Catalog
L2004D6 Teccor® Sensitive Triac ;; Package= TO-252AA SM D-pak
L2004E512V Thyristor Product Catalog
L2004F31 Teccor® Sensitive Triac ;; Package= TO-252AA SM D-pak
L2004F512V Thyristor Product Catalog
L2004F61 Teccor® Sensitive Triac ;; Package= TO-252AA SM D-pak
L2004L512V Thyristor Product Catalog

K2500G : Teccor® Sidac ;; Package= TO-92 Two-lead

L6004F61 : Teccor® Sensitive Triac ;; Package= TO-252AA SM D-pak

P1800ZB : Teccor® Four Port Metallic Line Protector ;; Package= Sip Single In-line Package (Quad Metallic)

P2202ZC : Teccor® Four Port Longitudinal Two-chip Protector ;; Package= Sip Single In-line Package (Quad Longitudinal)

Q2008F12V : Thyristor Product Catalog

Q2012L : Thyristor Product Catalog

S1006F1 : SCRS 1-70 Amps Non-sensitive Gate

S6008LS2 : Teccor® Sensitive SCR ;; Package= TO-92 Three-lead

S6065K : Teccor® SCR ;; Package= TO-252AA SM D-pak

P3500Z : Solid State Crowbar Devices

P3203U : Solid State Crowbar Devices

 
0-C     D-L     M-R     S-Z