|Category||Semiconductors => Amplifiers => Operational Amplifiers (Op Amps) => Ultra-Low-Power Op Amps (<=250uA)|
|Part family||TLC25L4A LinCMOS(TM) Quad Operational Amplifier|
|Description||LinCMOS(TM) Quad Operational Amplifier 14-PDIP 0 to 70|
|Company||Texas Instruments, Inc.|
|Datasheet||Download TLC25L4A datasheet
|Cross ref.||Similar parts: CA3100E, CA3100T, JM38510/10101BPX, JM38510/10104BGA, JM38510/10104BGC, JM38510/10104SGA, JM38510/11401BGA, JM38510/11401BGC, JM38510/11401SGA, JM38510/11403BGA|
|Operating Temperature Range(C)||0 to 70|
|Vn at 1kHz(Typ)(nV/rtHz)||68|
|Rail-to-Rail||In to V-|
|Total Supply Voltage(Max)(+5V=5, +/-5V=10)||16|
|Number of Channels(#)||4|
|Iq per channel(Typ)(mA)||0.01|
|Iq per channel(Max)(mA)||0.017|
|Vos (Offset Voltage @ 25C)(Max)(mV)||5|
|Input Bias Current(Max)(pA)||60|
|Total Supply Voltage(Min)(+5V=5, +/-5V=10)||1.4|
|Approx. Price (US$)||2.88 | 1ku|
|Pin nb||Package type||Ind std||JEDEC code||Package qty||Carrier||Device mark||Width (mm)||Length (mm)||Thick (mm)||Pitch (mm)|
|TLC25L4, TLC25L4A, TLC25L4B PSpice Model - ZIP (01/10/2002)|
A-Suffix Versions Offer 5-mV VIO B-Suffix Versions Offer 2-mV VIO Wide Range of Supply Voltages 16 V True Single-Supply Operation Common-Mode Input Voltage Includes the Negative Rail Low Noise. 25 nV/Hz Typ = 1 kHz (High-Bias Version)
description symbol (each amplifier) The IN + and TL25M4B are low-cost, low-power quad OUT operational amplifiers designed to operate with IN single or dual supplies. These devices utilize the Texas Instruments silicon gate LinCMOS process, giving them stable input-offset voltages that are available in selected grades 10 mV maximum, very high input impedances, and extremely low input offset and bias currents. Because the input common-mode range extends to the negative rail and the power consumption is extremely low, this series is ideally suited for battery-powered or energy-conserving applications. The series offers operation down a 1.4-V supply, is stable at unity gain, and has excellent noise characteristics.
These devices have internal electrostatic-discharge (ESD) protection circuits that prevent catastrophic failures at voltages V as tested under MIL-STD-883C, Method 3015.1. However, care should be exercised in handling these devices as exposure to ESD may result in degradation of the device parametric performance. Because of the extremely high input impedance and low input bias and offset currents, applications for these devices include many areas that have previously been limited to BIFET and NFET product types. Any circuit using high-impedance elements and requiring small offset errors is a good candidate for cost-effective use of these devices. Many features associated with bipolar technology are available with LinCMOS operational amplifiers without the power penalties of traditional bipolar devices.
Available options TA VIOmax 2 mV PACKAGED DEVICES SMALL OUTLINE (D) TLC25M4ACD TLC25M4BCD PLASTIC DIP (N) TLC25M4ACN TLC25M4BCN TSSOP (PW) TLC25L4CPW TLC25M4CPW CHIP FORM (Y) TLC25L4Y TLC25M4Y
The D package is available taped and reeled. Add the suffix R to the device type (e.g., TLC254CDR). Chips are tested at 25°C.
PRODUCTION DATA information is current as of publication date. Products conform to specifications per the terms of Texas Instruments standard warranty. Production processing does not necessarily include testing of all parameters.
General applications such as transducer interfacing, analog calculations, amplifier blocks, active filters, and signal buffering are all easily designed with these devices. Remote and inaccessible equipment applications are possible using their low-voltage and low-power capabilities. These devices are well suited to solve the difficult problems associated with single-battery and solar-cell-powered applications. This series includes devices that are characterized for the commercial temperature range and are available in 14-pin plastic dip and the small-outline packages. The device is also available in chip form. These devices are characterized for operation from to 70°C.
DEVICE FEATURES PARAMETER Supply current (Typ) Slew rate (Typ) Input offset voltage (Max) TLC25L4BC, TLC25M4BC Offset voltage drift (Typ) Offset voltage temperature coefficient (Typ) Input bias current (Typ) TLC25L4_C (LOW BIAS) µA 0.04 V/µA mV 0.1 µV/month 0.7 µV/°C pA TLC25M4_C (MEDIUM BIAS) µA 0.6 V/µA mV 0.1 µV/month 2 µV/°C pA TLC254_C (HIGH BIAS) µA 4.5 V/µA mV 0.1 µV/month 5 µV/°C 1 pAInput offset current (Typ) 1 pA The long-term drift value applies after the first month.
These chips, when properly assembled, display characteristics similar to the TLC25_4C. Thermal compression or ultrasonic bonding may be used on the doped-aluminum bonding pads. Chips may be mounted with conductive epoxy or a gold-silicon preform.
CHIP THICKNESS: 15 TYPICAL BONDING PADS: × 4 MINIMUM TJmax = 150°C TOLERANCES ARE ± 10%. ALL DIMENSIONS ARE IN MILS. PIN (11) IS INTERNALLY CONNECTED TO BACKSIDE OF CHIP.
|Related products with the same datasheet|
|Some Part number from the same manufacture Texas Instruments, Inc.|
|TLC25L4ACD ti TLC25L4A, LinCMOS(TM) Quad Operational Amplifier|
|TLC25L4BCD ti TLC25L4B, LinCMOS(TM) Quad Operational Amplifier|
|TLC25L4CD ti TLC25L4, Quad Upower Low-voltage Operational Amplifier|
|TLC25M2ACD ti TLC25M2A, Lincmos Dual Operational Amplifier|
|TLC25M2B Lincmose Dual Operational Amplifiers|
|TLC25M2BCD ti TLC25M2B, LinCMOS(TM) Dual Operational Amplifier|
|TLC25M2CD ti TLC25M2, Dual Low-power Low-voltage Operational Amplifier|
FX366 : Amps/tacs Quad Filter Array.
HN3B01F : PNP Epitaxial Type ( Audio Frequency General Purpose Amplifier Applications ).
IMP811 : Power. 4-pin up Voltage Supervisor With Manual Reset. The IMP811/IMP812 are low-power supervisors designed to monitor voltage levels 3.0V, 3.3V and 5.0V power supplies in low-power microprocessor (µP), microcontroller (µC) and digital systems. Each a debounced manual reset input. The IMP811/812 are improved drop-in replacements for the Maxim MAX811/812 with extended temperature s 105°C. A reset signal.
LG1628BXA : Lg1628axa Sonet/sdh 2.488 Gbits/s Transimpedance Amplifier. High data rate: 2.5 Gbits/s High gain: 5.8 k transimpedance Complementary 50 outputs Low noise Ultrawide dynamic range Single 5.2 V ECL power supply A complete receiver/regenerator can be constructed with an LG1628AXA followed an LG1605 limiting amplifier and LG1600 clock and data regenerator. Figure 1 shows the block diagram of the LG1628AXA transimpedance.
LM2903 : Low Offset Voltage Dual Comparator. The LM393 series are dual independent precision voltage comparators capable of single or split supply operation. These devices are designed to permit a common mode rangetoground level with single supply operation. Input offset voltage s as low 2.0 mV make this device an excellent selection for many applications in consumer, automotive, and industrial.
LM9820 : 12-bit Image Sensor Processor Analog Front End. The LM9810 and LM9820 are high performance Analog Front Ends (AFEs) for image sensor processing systems. The LM9810/20 performs all the analog and mixed signal functions (correlated double sampling, color specific gain and offset correction, and analog to digital conversion) necessary to digitize the output of a wide variety of CIS and CCD sensors.
LT1311 : LT1311, Quad 12MHz, 145ns Settling Precision Current-to-voltage Converter For Optical Disk Drives.
MAX4599 : Low-Voltage, Single-Supply, SPDT Analog Switch in SC70. The MAX4599 single-pole/double-throw (SPDT) switch operates from to +5.5V single supply. It offers 60 max on-resistance (RON) at +5V and fast switching times (tON = 30ns max, tOFF = 25ns max). The MAX4599 excellent RON flatness (4 max) and matching (1 max) between channels. This device also offers 5pC max charge injection. The MAX4599 is available in tiny.
MC33486DH : Power High Side Switches. MC33486 Dual High Side Switch For H-bridge Automotive Applications.
MC34164-3 : Power. 3v Undervoltage Sensing Circuit. The MC33164-3 and MC34164-3 are undervoltage sensing circuits designed specifically for use as reset controllers in microprocessor-based systems. They offer the designer an economical, space efficient solution for low supply voltage detection when used in combination with a single pull-up resistor. Adding one capacitor offers the functionality of a programmable.
NJM2220S : Video Synchronous Detector.
TL072AID : Low Noise J-FET Dual Operational Amplifiers. WIDE COMMON-MODE (UP TO VCC+) AND DIFFERENTIAL VOLTAGE RANGE LOW INPUT BIAS AND OFFSET CURRENT LOW NOISE = 15nV/Hz (typ) OUTPUT SHORT-CIRCUIT PROTECTION HIGH INPUT IMPEDANCE JFET INPUT STAGE LOW HARMONIC DISTORTION : 0.01% (typ) INTERNAL FREQUENCY COMPENSATION LATCH UP FREE OPERATION HIGH SLEW RATE : 16V/µs (typ) The TL072, TL072A and TL072B are high.
TLV2775 : . TLV277x, TLV277xA FAMILY OF 2.7-V HIGH-SLEW-RATE RAIL-TO-RAIL OUTPUT OPERATIONAL AMPLIFIERS WITH SHUTDOWN High Slew Rate. 10.5 V/µs Typ High-Gain Bandwidth. 5.1 MHz Typ Supply Voltage Range 5.5 V Rail-to-Rail Output 360 µV Input Offset Voltage Low Distortion Driving 600- 0.005% THD+N 1 mA Supply Current (Per Channel) 17 nV/Hz Input Noise Voltage 2 pA Input.
UC3914 : Power. 5v to 35v Hot Swap Power Manager. to 35V Operation Precision Maximum Current Control Precision Fault Threshold Programmable Average Power Limiting Programmable Overcurrent Limit Shutdown Control Charge Pump for Low RDS(on) High-Side Drive Latch Reset Function Available Output Drive VGS Clamping Fault Output Indication 18 Pin DIL and SOIC Packages The UC3914 family of Hot Swap Power.
BUF602 : High Speed, Closed Loop Buffer The BUF602 is a closed-loop buffer recommended for a wide range of applications. Its wide bandwidth (1000MHz) and high slew rate (8000V/µs) make it ideal for buffering very high-frequency signals. For AC-coupled applications, an optional mid-point reference (VREF) is provided, reducing the number of external components.
LTC6401IUD-8 : 1.3GHz Low Noise, Low Distortion Differential ADC Driver For 140MHz IF The LTC6401-20 is a high-speed differential amplifier targeted at processing signals from DC to 140MHz. The part has been specifically designed to drive 12-, 14- and 16-bit ADCs with low noise and low distortion, but can also be used as a general-purpose broadband gain block. The LTC6401-20.
MAX9065 : Ultra-Small, Low-Power Window Comparator In 4 UCSP™ And 5-SOT23 The MAX9065 is an ultra-small, low-power, window comparator ideal for a wide variety of portable electronics applications such as cell phones, portable media players, and notebooks that have extremely tight board space and power constraints. It comes in both a 4-bump UCSP package with a 1mm x 1mm footprint.
MAX4885AE : High-Bandwidth, VGA 2:1 Switch With ±15kV ESD Protection The MAX4885AE integrates high-bandwidth analog switches, level-translating buffers, and level-translating FET switches to implement a complete 2:1 multiplexer for VGA signals. The device provides three very high-frequency 900MHz (typ) SPDT switches for RGB signals, two low-frequency clamping switches.