Details, datasheet, quote on part number: TLC25M2B
PartTLC25M2B
CategoryAnalog & Mixed-Signal Processing => Amplifiers
DescriptionLincmose Dual Operational Amplifiers
CompanyTexas Instruments, Inc.
DatasheetDownload TLC25M2B datasheet
Quote
Find where to buy
 
  

 

Features, Applications

A-Suffix Versions Offer 5-mV VIO B-Suffix Versions Offer 2-mV VIO Wide Range of Supply Voltages 16 V True Single-Supply Operation Common-Mode Input Voltage Includes the Negative Rail Low Noise. 30 nV/Hz Typ = 1 kHz (High-Bias Versions)

description

The TLC252, TLC25L2, and TLC25M2 are OUT IN low-cost, low-power dual operational amplifiers designed to operate with single or dual supplies. These devices utilize the Texas Instruments silicon gate LinCMOSTM process, giving them stable input offset voltages that are available in selected grades 10 mV maximum, very high input impedances, and extremely low input offset and bias currents. Because the input common-mode range extends to the negative rail and the power consumption is extremely low, this series is ideally suited for battery-powered or energy-conserving applications. The series offers operation down a 1.4-V supply, is stable at unity gain, and has excellent noise characteristics. These devices have internal electrostatic-discharge (ESD) protection circuits that prevent catastrophic failures at voltages V as tested under MIL-STD-883C, Method 3015.1. However, care should be exercised in handling these devices as exposure to ESD may result in a degradation of the device parametric performance.

AVAILABLE OPTIONS TA VIOmax 2 mV PACKAGED DEVICES SMALL OUTLINE (D) TLC25M2ACD TLC25M2BCD PLASTIC DIP (P) TLC25M2ACP TLC25M2BCP CHIP FORM (Y) TLC25L2Y TLC25M2Y

The D package is available taped and reeled. Add the suffix R to the device type (e.g., TLC252CDR). Chips are tested at 25C.

Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet. LinCMOS is a trademark of Texas Instruments Incorporated.

PRODUCTION DATA information is current as of publication date. Products conform to specifications per the terms of Texas Instruments standard warranty. Production processing does not necessarily include testing of all parameters.

Because of the extremely high input impedance and low input bias and offset currents, applications for the TLC252/ 25_2 series include many areas that have previously been limited to BIFET and NFET product types. Any circuit using high-impedance elements and requiring small offset errors is a good candidate for cost-effective use of these devices. Many features associated with bipolar technology are available with LinCMOSTM operational amplifiers without the power penalties of traditional bipolar devices. General applications such as transducer interfacing, analog calculations, amplifier blocks, active filters, and signal buffering are all easily designed with the / 25_2 series devices. Remote and inaccessible equipment applications are possible using their low-voltage and low-power capabilities. The / 25_2 series is well suited to solve the difficult problems associated with single-battery and solar-cell-powered applications. This series includes devices that are characterized for the commercial temperature range and are available in 8-pin plastic dip and the small-outline package. The device is also available in chip form. The / 25_2 series is characterized for operation from to 70C.

These chips, properly assembled, display characteristics similar to the / 25_2. Thermal compression or ultrasonic bonding may be used on the doped-aluminum bonding pads. Chips may be mounted with conductive epoxy or a gold-silicon preform.

CHIP THICKNESS: 15 TYPICAL BONDING PADS: 4 MINIMUM TJMAX = 150C TOLERANCES ARE 10%. ALL DIMENSIONS ARE IN MILS. PIN (4) IS INTERNALLY CONNECTED TO BACKSIDE OF CHIP.


 

Some Part number from the same manufacture Texas Instruments, Inc.
TLC25M2BC
TLC25M2BCD ti TLC25M2B, LinCMOS(TM) Dual Operational Amplifier
TLC25M2C
TLC25M2CD ti TLC25M2, Dual Low-power Low-voltage Operational Amplifier
TLC25M2Y
TLC25M4
TLC25M4A
TLC25M4ACD ti TLC25M4A, LinCMOS(TM) Quad Operational Amplifier
TLC25M4B
TLC25M4BCD ti TLC25M4B, LinCMOS(TM) Quad Operational Amplifier
TLC25M4C
TLC25M4CD ti TLC25M4, Quad Low-power Low-voltage Operational Amplifier
TLC25M4Y
TLC25MX
TLC25MXA
TLC25MXB
TLC25X
TLC25XA
TLC25XB
TLC2652
TLC2652A
Same catergory

5962-9555601Q2A : ti TLE2425, Precision Virtual Ground. 2.5-V Virtual Ground for 5-V/GND Analog Systems High Output-Current Capability Sink or Source. 20 mA Typ Micropower Operation. 170 A Typ Excellent Regulation Characteristics Output Regulation 45 V Typ +15 V Typ mA Input Regulation = 1.5 V/V Typ Low-Impedance Output. 0.0075 Typ Macromodel Included In signal-conditioning applications using a single.

AN7511S : BTL Audio Power ic. The AN7510/7520 series to 3W BTL audio power amplifier IC. Equipped with a standby function and mute or DC volume circuit, the series includes a lineup of single and dual output models. With simplified set design due to minimum external components, this IC has a wide variety of applications. Operating power sourcs voltage: to 13.5V. Built-in standby.

C3077-70 : 2/3-inch CCD Video Camera.

EL5111 : Single 60MHz Rail-to-rail Input-output op Amp The EL5111 is a Low Power, High Voltage Rail-to-rail Input-output Single Amplifier. Operating on Supplies Ranging From 5V to 15V, While Consuming Only 2.5mA Per Amplifier, The EL5111 Has a Bandwidth of 60MHz (-3dB). It Also Provides Common Mode Input Ability Beyond The Supply Rails, as Well as Rail-to-rail.

HYB3164805AJ : 8m X 8-bit Dynamic RAM. 388 608 words by 8-bit organization 70 C operating temperature Hyper Page Mode - EDO - operation Performance: -40 tRAC tCAC tAA tRC tHPC RAS access time CAS access time Access time from address Read/write cycle time Hyper page mode (EDO) cycle time ns Single V 0.3V) power supply Low power dissipation: max. 450 active mW ( HYB 3164805AJ/AT(L)-40) max.

ISO100 : . q EASY TO USE, SIMILAR AN OP AMP VOUT/IIN = RF, Current Input VOUT/VIN = RF/RIN, Voltage Input q 100% TESTED FOR BREAKDOWN: 750V Continuous Isolation Voltage q ULTRA-LOW LEAKAGE: 0.3A, max, 240V/60Hz q WIDE BANDWIDTH: q 18-PIN DIP PACKAGE APPLICATIONS q INDUSTRIAL PROCESS CONTROL Transducer Sensing (Thermocouples, RTD, Pressure Bridges) to 20mA Loops.

MN4SV1716BT-10 : 16m Bit Synchronous Dynamic RAM.

OPA2704EA/250 : ti OPA2704, 12V, CMOS, Rail-to-rail I/O, Operational Amplifier. q RAIL-TO-RAIL INPUT AND OUTPUT q WIDE SUPPLY RANGE: Single Supply: to 12V Dual Supplies: 6 q LOW QUIESCENT CURRENT: 160A q FULL-SCALE CMRR: 90dB q LOW OFFSET: 160V q HIGH SPEED: s q MicroSIZE PACKAGES: TSSOP-14 q LOW INPUT BIAS CURRENT: 1pA The OPA703 and OPA704 series op amps are optimized for applications requiring rail-to-rail input and output.

OPA277P : ti OPA277, High Precision Operational Amplifiers. For most current data sheet and other product information, visit www.burr-brown.com q ULTRA LOW OFFSET VOLTAGE: 10V q ULTRA LOW DRIFT: 0.1V/C q HIGH OPEN-LOOP GAIN: 134dB q HIGH COMMON-MODE REJECTION: 140dB q HIGH POWER SUPPLY REJECTION: 130dB q LOW BIAS CURRENT: 1nA max q WIDE SUPPLY RANGE: 18V q LOW QUIESCENT CURRENT: 800A/amp q SINGLE, DUAL,.

PCA8521 : PCA8521; Infrared Remote Control Transmitter RC5. Product Supersedes data of 1997 Jul 03 File under Integrated Circuits, IC02 1999 Jun 15 RC5 protocol Maximum of: 56 keys (20-pin version) 30 keys (16-pin version). Option of multi-system or single system transmitter Multi-system: maximum 8 systems, selection by key Single system: maximum 8 different systems per IC, selection by jumper wire or switch.

TC9246P : PLL ic For Digital Audio.

TL601 : SPDT. P-mos Analog Switches. Switch 10-V Analog Signals TTL Logic Capability 5-to 30-V Supply Ranges Low (100 ) On-State Resistance High (1011 ) Off-State Resistance 8-Pin Functions The TL604, TL607, and TL610 are a family of monolithic P-MOS analog switches that provide fast switching speeds with high roff/ron ratio and no offset voltage. The p-channel enhancement-type MOS switches.

TLC14 : Butterworth Fourth-order Low-pass Switched-capacitor Filters. Low Clock-to-Cutoff-Frequency Ratio Error 1% Filter Cutoff Frequency Dependent Only on External-Clock Frequency Stability Minimum Filter Response Deviation Due to External Component Variations Over Time and Temperature Cutoff Frequency Range From to 30 kHz, VCC to 12-V Operation Self Clocking or TTL-Compatible and CMOS-Compatible Clock Inputs Low Supply-Voltage.

TLV4113 : Family of High Output Drive Operational Amplifiers With Shutdown. TLV4112, TLV4113 FAMILY OF HIGH OUTPUT DRIVE OPERATIONAL AMPLIFIERS WITH SHUTDOWN High Output Drive. >300 mA Rail-To-Rail Output Unity-Gain Bandwidth. 2.7 MHz Slew Rate. 1.5 V/s Supply Current. 700 A/Per Channel Supply Voltage Range. 6 V Specified Temperature Range: to 70C. Commercial Grade to 125C. Industrial Grade Universal OpAmp EVM The TLV411x.

TXS75ZA : Input Voltage Range 3675v DC Single 80100a Output 1500v DC I/o Electrical Strength Test Voltage.

UCC3918 : Power. Low On-resistance Hot Swap Power Manager. D Integrated 0.075- Power MOSFET 6 V Operation D External Analog Control of Fault Current from 4 A Independent Analog Control of Current Limit 5 A Fast Overload Protection Unidirectional Switch Minimal External Components 1-A ICC When Disabled Programmable On Time Programmable Start Delay Fixed 3% Duty Cycle Pin 5 serves as the lowest impedance to the electrical.

V23826-C18-C366 : DC/DC ( 3.3 V ) Single Mode 155 MBD Atm/sdh/sonet 1x9 Transceiver Extended Temperature Range.

TS3A4742 : 0.9-Ohm Low-Voltage Single-Supply Dual SPST Analog Switch The TS3A4741/TS3A4742 are low ON-state resistance (ron), low-voltage, dual single-pole/single-throw (SPST) analog switches that operate from a single 1.6-V to 3.6-V supply. These devices have fast switching speeds, handle rail-to-rail analog signals, and consume very low quiescent power. The digital.

NX3L1T384 : Single-pole Single-throw Analog Switch The NX3L1T384 provides one single-pole single-throw analog switch function. It has two input/output terminals (Yand Z) and an active LOW enable input pin (E). When E is HIGH, the analog switch is turned off. Schmitt trigger action at the enable input (E) makes the circuit tolerant to slower input rise and fall.

TSV912H : Datasheet High Temperature Rail-to-rail Input/output 8 MHz Operational Amplifiers Datasheet High temperature rail-to-rail input/output 8 MHz operational amplifiers.

 
0-C     D-L     M-R     S-Z