Details, datasheet, quote on part number: TMS29F040-12C5FML
CategoryMemory => Flash
Descriptionti TMS29F040, 4 194 304-Bit Flash Memory
CompanyTexas Instruments, Inc.
DatasheetDownload TMS29F040-12C5FML datasheet
Find where to buy


Features, Applications

V See / TMS29VF040 Data Sheet (Literature Number V See / TMS29VF040 Data Sheet Organization. By 8 Bits Eight Equal Sectors of 64K Bytes Any Combination of Sectors Can Be Erased Any Combination of Sectors Can Be Marked as Read-Only Compatible With JEDEC Electrically Erasable Programmable Read-Only Memory (EEPROM) Command Set Fully Automated On-Chip Erase and Byte-Program Operations 100 000 Program / Erase Cycles Erase-Suspend/ Erase-Resume Operation Compatible With JEDEC Byte-Wide Pinouts Low-Current Consumption Active Read. 20 mA Typical Active Program / Erase. 30 mA Typical All Inputs/Outputs TTL-Compatible

PIN NOMENCLATURE E G VCC VSS W Address Inputs (programming) / Outputs Chip Enable Output Enable 5-V Power Supply Ground Write Enable


The (4194304-bit), 5-V single-supply, programmable read-only memory that can be electrically erased and reprogrammed. This device is organized as eight independent 64K-byte sectors and is offered with access times between 60 ns and 120 ns. An on-chip state machine controls the program and erase operations. The embedded byte-program and sector / chip-erase functions are fully automatic. The command set is compatible with that of JEDEC 4M-bit EEPROMs. A suspend / resume feature allows access to unaltered memory sectors during a sector-erase operation. Data-protection of any sector combination is accomplished using a hardware sector-protection feature. Device operations are selected by writing JEDEC-standard commands into the command register using standard microprocessor write timings. The command register acts as input to an internal-state machine that interprets the commands, controls the erase and programming operations, and outputs the status of the device, the data stored in the device, and the device algorithm-selection code. On initial power-up operation, the device defaults to the read mode. The TMS29F040 is offered a 32-pin plastic leaded chip carrier (FM suffix) using 1.27-mm (50-mil) lead pitch and a 32-pin thin small-outline package (DD suffix).

Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.

PRODUCTION DATA information is current as of publication date. Products conform to specifications per the terms of Texas Instruments standard warranty. Production processing does not necessarily include testing of all parameters.

Temperature Range Designator L = Commercial E = Extended 85C ) Package Designator FM = Plastic Leaded Chip Carrier DD = Thin Small-Outline Package

Command Register W Erase-Voltage Generator Program-Voltage Generator Data Latch


Related products with the same datasheet
Some Part number from the same manufacture Texas Instruments, Inc.
TMS29F040-70C5DDL ti TMS29F040, 4 194 304-Bit Flash Memory
TMS29F400 524 288 BY 8-bit/262 144 BY 16-bit Flash Memory
TMS29LF008B ti TMS29LF008B, 8 388 608-Bit Boot-sector Flash Memories
TMS29LF008T ti TMS29LF008T, 8 388 608-Bit Boot-sector Flash Memory
TMS29LF040 ti TMS29LF040, 4 194 304-Bit Flash Memory
TMS29LF800B ti TMS29LF800B, 8 388 608-Bit Boot-sector Flash Memo
TMS29LF800T ti TMS29LF800T, 8 388 608-Bit Flash Memories
TMS29VF040 ti TMS29VF040, 4 194 304-BIT Flash Memory
TMS320 Floating-point Digital Signal Processors
TMS32020 Wide-band Analog Interface Circuit
TMS320A2400 Floating-point Digital Signal Processors
TMS320BC51 Tms320c5x Fixed Point DSP
TMS320BC51PQ ti TMS320BC51, Digital Signal Processors
TMS320BC52 Tms320c5x Fixed Point DSP
TMS320BC52PJ ti TMS320BC52, Digital Signal Processors
TMS320BC53 Tms320c5x Fixed Point DSP
TMS320BC53PQ ti TMS320BC53, Digital Signal Processor
TMS320BC53S Tms320c5x Fixed Point DSP
TMS320BC53SPZ ti TMS320BC53S, Digital Signal Processor
TMS320BC57S Tms320c5x Fixed Point DSP
TMS320BC57SPGE57 ti TMS320BC57S, Digital Signal Processors

GC3021A :

LM124N : ti LM124, Quad General-purpose Operational Amplifier

PT3328N : Plug-in Power Solutions->Isolated->Single Output ti PT3328, 5.2Vout 30W 48V-Input ISOlated DC/DC Converter

SN74AUC1G06YZAR : Single Gates ti SN74AUC1G06, Single Inverter Buffer/driver With Open-drain Output

THS3061DGNR : ti THS3061, High-Voltage, High Slew-rate Current Feedback Amplifier

THS3096PWPR : Dual- High-Voltage, Low Distortion, Current-feedback Operational Amplifier With Power-down

TLE2072AMUB : ti TLE2072A, Excalibur Low-noise High-speed JFET-input Dual Operational Amplifier

UA78L08A :

TLV341IDCKTG4 : Low-voltage Rail-to-rait Output CMOS Operational Amplifiers

TMP3C6414CGLZA300 : Fixed-point Digital Signal Processors

OPA2317IDGKT : Operational Amplifiers - Op Amps Dual,Low Offset,RRIO Op Amp Specifications: Manufacturer: Texas Instruments ; Number of Channels: 2 ; Common Mode Rejection Ratio (Min): 95 dB ; Input Offset Voltage: 20 uV ; Input Bias Current (Max): 275 pA ; Operating Supply Voltage: 1.8 V to 5.5 V ; Mounting Style: SMD/SMT ; Package / Case: VSSOP-8 ; Slew Rate: 0.15 V/us ;

ADC34J25EVM : Data Conversion IC Development Tools ADC34J25 Eval Mod Texas Instruments ADC34J2x 12-Bit Analog-to-Digital Converters are a high-linearity, ultra-low power, dual-channel, 12-bit, 50-MSPS to 160-MSPS, analog-to-digital converters (ADCs). These devices are designed specifically to support demanding, high input frequency signals with large dynamic range

0-C     D-L     M-R     S-Z