Details, datasheet, quote on part number: K1570AQH
PartK1570AQH
CategoryTiming Circuits => Oscillators => VCXO (Voltage Controlled Crystal Oscillators)
DescriptionPackage Description = 14 Pin Dip ;; Frequency = 25.000 to 52.000 MHZ ;; Output Logic = CMOS/ttl ;; Supply Voltage = 5.0 Volt
CompanyM-tron Industries, Ltd
DatasheetDownload K1570AQH datasheet
  

 

Features, Applications

5V Voltage Controlled Crystal Oscillators ! Applications: Phase-Locked Loops (PLL's); Clock Recovery; Reference Signal Tracking; Synthesizers; Frequency Modulation/Demodulation 16-pin DIL Package to 52.0 MHz Frequency Range to 4.5V Control Voltage ±25ppm Stability to 85°C Operating Temperature

Model Frequency Range (MHz) Input Current (mA) Frequency Control Function Deviation (ppm) Minimum Maximum Linearity Modulation Bandwidth (±3dB) Nominal Control Voltage (V) Control Voltage Range (V) Transfer Function Input Impedance Frequency Stability (ppm) Overall to +85oC Temperature Range (oC) Operating Storage Supply Voltage (V) Symmetry CMOS/TTL Start Up Time (ms) Typical SSB Phase Noise (dBC/Hz) Offset from Carrier +125oC +5.0V Inclusive of Calibration, Temperature, Voltage, Load and Aging to 4.5 Positive < 45

(For Custom Deviation Range, Vc Range, etc. - Consult Factory)
K1570AQHX - Specify Frequency "Blank" to 70°C Operating Temp. "M" to +85°C Operating Temp.

2553 N. Edgington Street, Franklin Park, 60131 " Phone: 847.451.1000 " Fax: 800-888-1499 or www.champtech.com

PIN FUNCTION Voltage Control Gnd/ & Case Gnd Output + VCC

Temperature Cycle Mechanical Shock Vibration Humidity Steady State Thermal Shock Electrostatic Discharge Solderability Hermeticity Resistance to Soldering Lead Integrity Marking Permanence Life Test

MIL-STD-833, Mtd 1010, Cond. B MIL-STD-883, Mtd 2002, Cond. B MIL-STD 883, Mtd 2007, Cond. B MIL-STD-202, Mtd 103 MIL-STD-883, Mtd 1011.7 Cond. B MIL-STD-883, Mtd 3015 Class II MIL-STD-883, Mtd 2022.2 MIL-STD-883, Mtd 1014.8, Cond. A1

DESCRIPTION

to +125°C; Air-to-Air; 100 cycles; 10 min. dwell 1500 g's 20-2000 Hz; 0.06 inch; 15g's; 3 planes 40°C; 90%-95% R.H.; 56 days to 0°C; Water-to-Water; 15 cycles 4 KV Threshold Solder dip; Meniscograph Criteria Mass spectro. x 10-8 atmos. CC/sec He

MIL-STD-202, Mtd 210D, Cond. 260°C; 10 seconds: 1 inch/sec. MIL-STD-883, Mtd 2004.5, Cond. A, B1 Lead tension & bend stress MIL-STD-883, Mtd 2015.8 MIL-STD-883, Mtd 1005.6 Resistance to solvents

2553 N. Edgington Street, Franklin Park, 60131 " Phone: 847.451.1000 " Fax: 800-888-1499 or www.champtech.com


 

Some Part number from the same manufacture M-tron Industries, Ltd
K1573A Package Description = 14 Pin Dip ;; Frequency = 1.000 to 52.000 MHZ ;; Output Logic = CMOS ;; Supply Voltage = 3.3 Volt
K1601 Package Description = 14 Pin MTL Dil ;; Frequency = 16.000 to 30.000 MHZ ;; Output Logic = Clipped Sine Wave ;; Supply Voltage = 5V
K1601T Package Description = 14 Pin Dip ;; Frequency = 2.000 to 30.000 MHZ ;; Output Logic = CMOS/ttl ;; Supply Voltage = 5.0 Volt
K1601TE
K1602 Package Description = 14 Pin MTL Dil ;; Frequency = 16.000 to 30.000 MHZ ;; Output Logic = Clipped Sine Wave ;; Supply Voltage = 5V
K1602SE Package Description = 14 Pin Dip ;; Frequency = 90.000 to 115.000 MHZ ;; Output Logic = Siave ;; Supply Voltage = 5.0 Volt
K1602T Package Description = 14 Pin Dip ;; Frequency = 2.000 to 30.000 MHZ ;; Output Logic = CMOS/ttl ;; Supply Voltage = 5.0 Volt
K1602TE
K1603T
K1603TE
K1610 Package Description = 14 Pin Dip ;; Frequency = 1.000 to 27.000 MHZ ;; Output Logic = Clipped Siave ;; Supply Voltage = 5.0 Volt
K1610T Package Description = 14 Pin MTL Dil ;; Frequency = 2.000 to 30.000 MHZ ;; Output Logic = CMOS/ttl ;; Supply Voltage = 5V
K1613 Package Description = 14 Pin Dip ;; Frequency = 1.000 to 25.000 MHZ ;; Output Logic = Clipped Siave ;; Supply Voltage = 3.3 Volt
K1700A Package Description = 14 Pin MTL Dil ;; Frequency = 2.000 to 35.000 MHZ ;; Output Logic = CMOS/ttl ;; Supply Voltage = 5V
K17255B Package Description = 14 Pin Dip ;; Frequency = 155.520 MHZ ;; Output Logic = 10KH Pecl ;; Supply Voltage = 5.0 Volt
K3100G Package Description = 14 Pin MTL Dil ;; Frequency = 1.000 to 70.000 MHZ ;; Output Logic = CMOS ;; Supply Voltage = 3.3V
K3500G Package Description = 8 Pin MTL Dil ;; Frequency = 1.000 to 70.000 MHZ ;; Output Logic = CMOS ;; Supply Voltage = 3.3V
K500
K500F Package Description = 8 Pin MTL Dil ;; Frequency = 1.500 to 100.000 MHZ ;; Output Logic = CMOS/ttl ;; Supply Voltage = 5V
K57/3A Package Description = 8 Pin MTL Dil ;; Frequency = 1.000 to 52.000 MHZ ;; Output Logic = CMOS ;; Supply Voltage = 3.3V
K570A Package Description = 8 Pin Dip ;; Frequency = 1.000 to 52.000 MHZ ;; Output Logic = CMOS/ttl ;; Supply Voltage = 5.0 Volt
Same catergory

CDC392 : General Purpose/. 1-to-6 Clock Driver Select Polarity 3-s. TO 6-LINE CLOCK DRIVER WITH SELECTABLE POLARITY AND 3-STATE OUTPUTS Low Output Skew for Clock-Distribution and Clock-Generation Applications TTL-Compatible Inputs and CMOS-Compatible Outputs Distributes One Clock Input to Six Clock Outputs Polarity Control Selects True or Complementary Outputs Distributed VCC and GND Pins Reduce Switching Noise High-Drive.

CY2277A : Pentium II, 6 X 86, K6 Clock Synthesizer/driver For Desktop Mobile PCS With 82430TX And 2 Dimms or 3 So-dimms.

DS1315 : Phantom Time Chip. Real time clock keeps track of hundredths of seconds, minutes, hours, days, date of the month, months, and years Adjusts for months with fewer than 31 days Automatic leap year correction valid 2100 No address space required to communicate with RTC Provides nonvolatile controller functions for battery backup of SRAM Supports redundant battery attachment.

EM92601A : Dual PLL For 46/49 MHZ Cordless Phone. DUAL PLL FOR 46/49 MHZ CORDLESS PHONE DUAL PLL FOR 46/49 MHZ CORDLESS PHONE The EM92600/1A series are developed for 46/49 MHz of 10 channels band frequency of cordless telephone which is used in U.S.A. These devices are dual phase-locked loop frequency synthesizers contained ROM counters for receive and transmit loops with two independent phase detect.

ICS9DB104 : Four Output Differential Buffer For Pci-express. Recommended Application: DB400 Intel Yellow Cover part with PCI-Express support. Output : - 0.7V current-mode differential output pairs Supports zero delay buffer mode and fanout mode Bandwidth programming available Key s: Outputs cycle-cycle jitter: < 50ps Outputs skew: 50ps 300ppm frequency accuracy on output clocks /Benefits: Supports tight ppm accuracy.

IDT2309NZ : The IDT2309NZ is a Low-cost Buffer Designed to Distribute High-speedclocks in Mobile PC Systems And Desktop PC Systems With SDRAMsupport. This Part Has Nine Outputs, Eight of Which CAN be Used to Drivetwo Dimms or Four SO-DIMMs, And The Remaining CAN be Used For Externalfeedback to a Pll. The IDT2309NZ Operates at 3.3V And Outputs CAN Runup to 133.33MHzThe.

M64892AFP : PLL Frequency Synthesizers. Serial Input PLL Frequency Synthesizer For Tv/vcr.

MC14544BCL : Bcd-to-seven Segment Latch/decoder/driver For Liquid Crystals. The MC14544B BCD­to­seven segment latch/decoder/driver is designed for use with liquid crystal readouts, and is constructed with complementary MOS (CMOS) enhancement mode devices. The circuit provides the functions a 4­bit storage latch and an 8421 BCD­to­seven segment decoder and driver. The device has the capability to invert the logic levels of the output.

MK1491-06 : CPU/Memory Specific PLL. Cyrix 5530 Clock Source. The is a low cost, low jitter, high performance clock synthesizer for National Semiconductor CS5530 based computer and portable appliance applications. Using patented analog Phase-Locked Loop (PLL) techniques, the device accepts a 14.318 MHz crystal input to produce multiple output clocks. It provides selectable PCI local bus and AC97 audio clocks,.

SF1189B-1 : SAW Resonators. Frequency = 280.0 ;; = Wlan if Filter. Designed for WLAN IF Applications Low Insertion Loss 1.7 mm Suface-Mount Case Single Ended or Differential Input and Output Differential Output Rating Maximum Incident Power in Passband Max. DC voltage between any 2 terminals Storage Temperature Range Max Soldering Profile Characteristic Nominal Center Frequency Passband Insertion Loss 3 dB Passband.

TS555 : Low Power. Low Power Single CMOS Timer. 110 µA typ at VCC 90 µA typ at VCC = 3V HIGH MAXIMUM ASTABLE FREQUENCY 2.7MHz PIN-TO-PIN AND FUNCTIONALLY COMPATIBLE WITH BIPOLAR NE555 WIDE VOLTAGE RANGE to +16V HIGH OUTPUT CURRENT CAPABILITY SUPPLY CURRENT SPIKES REDUCED DURING OUTPUT TRANSITIONS HIGH INPUT IMPEDANCE : 1012 OUTPUT COMPATIBLE WITH TTL,CMOS AND LOGIC MOS The is a single CMOS timer.

V613ME04 : Package Style = MINI-16 ;; Frequency (MHz) = 1805 to 1880 ;; N@10KHz (dBc/Hz) = -105 ;; Tuning Voltage (Vdc) = 1.00 to 8.00 ;; Tuning Sensitivity (MHz/V) = 21 ;; Power (dBm) = 3.00 ± 3.00 ;; Op.temp ( C) = -40 to 85 ;; VCC (Vdc) = 5.00 ;; Icc (mA) = 18.

VF394 : . HCMOS/TTL Compatible Hybrid VCXO 4 Pin Plastic J­Lead Input Break Down Voltage Storage Temp. Control Voltage Frequency Stability 2 TTL 15pF @50% Tr/Tf Voh Vol @2.5V 0.5 Overall, includes stability over temp., aging 5 yrs., etc. Ioh = ­0.8mA Iol V ms KHz V ppm @­3dB Rise/Fall Time Logic "1" Level Logic "0" Level Start­up Time Modulation Bandwidth Control.

VXE4 : Crystal Oscillators. 6 X 3.5 X 1.1 MM 4 Pads. Package Options Frequency Range Standard Frequencies Mode Stability Options 1.1 mm tall 4 pads 1 = Fundamental to 40 MHz) = 3rd Overtone to 100 MHz) = ±100 PPM = ±50 PPM = ±100 PPM = ±50 PPM = ±25 PPM = ±10 PPM = ±5 PPM 0 = Series Resonant pF ±25 PPM 25°C <60 Ohms 7 pF Maximum <5 ppm/1st year V = VITE X = Crystal 1.1 mm package = 3rd Overtone.

AD9510 : 800 MHz Clock Distribution, PLL Core, Dividers, Delay Adjust, 8 Outputs The AD9510 provides a multi-output clock distribution function along with an on-chip PLL core. The design emphasizes low jitter and low phase noise in order to maximize data converter clocking performance. Four independent LVPECL and four LVDS clock outputs operate to 800 MHz. Optional.

HMC584LP5 : The HMC584LP5 & HMC584LP5E are GaAs InGaP Heterojunction Bipolar Transistor (HBT) MMIC VCOs. The HMC584LP5 & HMC584LP5E integrate resonators, negative resistance devices, varactor diodes and feature half frequency and divide-by-4 outputs. The VCO’s phase noise performance is excellent over temperature, shock, and process due to the oscillator’s monolithic.

HMC791LC4B : Divide-By-2, Divide-By-4 0.1 To 28 GHz The HMC791LC4B is a low-noise divide-by-2, divide-by-4 designed to support input clock frequencies as high as 28 GHz. When an input clock signal is applied, divide-by-2 and divide-by-4 outputs are observed simultaneously. All input signals to the HMC791LC4B are terminated with 50? to ground on-chip, and may be either.

 
0-C     D-L     M-R     S-Z