Details, datasheet, quote on part number: U74AHC1G08-AF5-R
PartU74AHC1G08-AF5-R
Category
DescriptionBilateral Switch
CompanyUnisonic Technologies
DatasheetDownload U74AHC1G08-AF5-R datasheet
  

 

Features, Applications

DESCRIPTION

The is an analog switch which transmits signals from pin(Y Z) to pin or Y) with an active HIGH enable input pin (E). When pin E is LOW, the switch is turned off.

FEATURES

* Operation voltage range: 2~5.5V * Low power dissipation * Very low ON-resistance: 26 (typ.) Vcc=3.0V 16 (typ.) Vcc=4.5V 14 (typ.) at Vcc=5.5V

Order Number Normal Lead Free Plating U74AHC1G66-AL5-R U74AHC1G66L-AL5-R Package SOT-25 SOT-353 Packing Tape Reel Tape Reel

U74AHC1G66L-AF5-R (1)Packing Type (2)Package Type (3)Lead Plating (1) R: Tape Reel (3) L: Lead Free Plating, Blank: Pb/Sn

PIN NUMBER SYMBOL Y Z GND E Vcc DESCRIPTION independent input/output independent output/input ground enable input supply voltage

ABSOLUTE MAXIMUM RATINGS (unless otherwise specified)(Note 1)

SYMBOL RATINGS UNIT Supply Voltage VCC -0.5~7 V Enable Input Voltage -0.5~7 V Enable Input Clamp Current IEK -20 mA Switch Diode Current ISK 20 mA On-State Switch 25 mA VCC or GND Current ICC 75 mA Power Dissipation 250 mW Storage Temperature TSTG ~ +150 Note 1. The input and output voltage ratings may be exceeded if the input and output current ratings are observed. 2. Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. 3. To avoid drawing Vcc current out of pin Z, when switch current flows into pin Y, the voltage drop across the bidirectional switch must not exceed 0.4V. If the switch current flows into pin Z, no Vcc current will flow out of pin Y. In this case there is no limit for the voltage drop across the switch, but the voltage at pins Y and Z may not exceed Vcc or GND.

PARAMETER Supply Voltage Enable Input Voltage Switch Voltage Input Transition Rise or Fall Rate Operating Temperature SYMBOL VCC VE VS t/v TA SYMBOL VIH VCC=5.5V, VE =VCC or GND TEST CONDITIONS MIN 2 0 TYP 5.0 MAX 5.5 VCC 20 125 MAX UNIT V ns/V

PARAMETER High-Level Input Voltage Low-Level Enable Input Leakage Current State Switch Current ON-Resistance (Peak) OFF ON VIL IE(LEAK) IS UNIT V

Enable Input Capacitance 10 pF Maximum Switch CS Independent I/O 10 pF Capacitance Note 4. With supply voltages at or near 2V, the analog switch on-state resistance becomes very nonlinear. Only digital signals should be transmitted at these low supply voltages.

VCC=5.5V, |Vs |=VCC -GND VCC=5.5V VCC=2.0V, VIS= VCC to GND, IS=1mA RON(PEAK) VI s= VCC to GND, IS=10mA (Note VI s= VCC to GND, IS=10mA VCC=2.0V, VIS = VCC, IS=1mA VCC=2.0V, VIS = GND, IS=1mA VCC=3.0V~3.6V, VIS = VCC, IS=10mA RON(RAIL) VCC=3.0V~3.6V, VIS = GND, IS=10mA VCC=4.5V~5.5V, VIS= VCC, IS=10mA VCC=4.5V~5.5V, VIS= GND, IS=10mA VCC=5.5V,VE =VCC or GND,VIS= GND or IQ VCC, VOS=VCC or GND CE VE=VCC or GND


 

Related products with the same datasheet
U74AHC1G00-AF5-R
U74AHC1G00-AL5-R
U74AHC1G00L-AF5-R
U74AHC1G00L-AL5-R
U74AHC1G08
U74AHC1G08-AL5-R
U74AHC1G08L-AF5-R
U74AHC1G08L-AL5-R
U74AHC1G66
U74AHC1G66-AF5-R
U74AHC1G66-AL5-R
Some Part number from the same manufacture Unisonic Technologies
U74AHC1G08-AL5-R Bilateral Switch
88C49L-AF5-R Built-in Delay Circuit High-precision Voltage Detector
88C46L-AF5-R
8132-AB3-D-B Power Reset IC
79DXX Linear Integrated Circuit
88C21-AF5-R Built-in Delay Circuit High-precision Voltage Detector
UF630L-TA3-T 9A, 200v, 0.4 , N-channel Power Mosfets
P1786L-S08-R PWM Control 3A Step-down Converter
BAS70S Schottky Barrier Diodes
SK1812 Bipolar Latch TYPE HALL - Effect FOR High-temperature Operation
F6908-S08-R Single-phase Full-wave Motor Driver FOR FAN Motor
78DXX-TM3-T Linear Integrated Circuit
7N65-TF3-T 7 Amps, 650 Volts 7 Amps, 650 Volts
UT134F Triacs
82N32L-AB3-I-B Voltage Detectors
UF730-TA3-T 5.5a, 400v, 1.0 OHM, N-channel Power Mosfet
82N21-AB3-G-B Voltage Detectors
L2044L-D14-T DUAL Output Flasher
82N34L-AB3-I-B Voltage Detectors
P1696L-12-SO8-R 150khz, 2A PWM Step-down Dc/dc Converter
82N11L-AB3-I-B Voltage Detectors

U74HC00-P14-T : Quadruple 2-input Positive-nand Gates

LA2284AL-G09-T : 5-dot DUAL LED Level Meter Driver

8118-T92-D-B : Power Reset IC

UR6225L-27-AB3-C-R : 1.2 V FIXED POSITIVE REGULATOR, PDSO3 Specifications: Regulator Type: Standard ; Output Polarity: Positive ; Output Voltage Type: Fixed ; Package Type: SOT23, Other, LEAD FREE, SOT-23, 3 PIN ; Life Cycle Stage: ACTIVE ; Output Voltage: 1.18 to 1.22 volts ; IOUT: 0.0400 amps ; VIN: 2.2 to 10 volts

UT1036-T92-C-K : 3.6 V FIXED POSITIVE LDO REGULATOR, PSSO3 Specifications: Regulator Type: Low Dropout ; Output Polarity: Positive ; Output Voltage Type: Fixed ; Package Type: Other, SOT-89, 3 PIN ; Life Cycle Stage: ACTIVE ; Output Voltage: 3.42 to 3.78 volts ; VIN: 4.6 to 12 volts

UZ1085L-15-TA3-T : 1.5 V FIXED POSITIVE LDO REGULATOR, 1.4 V DROPOUT, SFM3 Specifications: Regulator Type: Low Dropout ; Output Polarity: Positive ; Output Voltage Type: Fixed ; Package Type: TO-220, Other, HALOGEN FREE, TO-220, 3 PIN ; Life Cycle Stage: ACTIVE ; Output Voltage: 1.47 to 1.53 volts ; IOUT: 3 amps ; VIN: 3 to 12 volts ; Dropout Voltage: 1.4 volts

78L05L-T92-R : 5 V FIXED POSITIVE REGULATOR, PDSO8 Specifications: Regulator Type: Standard ; Output Polarity: Positive ; Output Voltage Type: Fixed ; Package Type: Other, LEAD FREE, SOP-8 ; Life Cycle Stage: ACTIVE ; Output Voltage: 4.75 to 5.25 volts ; IOUT: 0.0700 amps ; VIN: 7 to 20 volts

78L06-T92-B : 6 V FIXED POSITIVE REGULATOR, BCY3 Specifications: Regulator Type: Standard ; Output Polarity: Positive ; Output Voltage Type: Fixed ; Package Type: Other, TO-92, 3 PIN ; Life Cycle Stage: ACTIVE ; Output Voltage: 5.7 to 6.3 volts ; IOUT: 0.0700 amps ; VIN: 8.5 to 20 volts

9013G-E-T92-K : 500 mA, 20 V, NPN, Si, SMALL SIGNAL TRANSISTOR, TO-92 Specifications: Polarity: NPN ; Package Type: HALOGEN FREE PACKAGE-3

 
0-C     D-L     M-R     S-Z